Table of Contents
Upgrading the suspension of your C63 M177 with H&R Springs can significantly enhance handling and improve the vehicle’s stance. This guide will walk you through the installation process, enabling you to complete the task in under two hours.
Why Choose H&R Springs?
H&R Springs are known for their quality and performance. Here are some reasons to consider them for your C63 M177:
- Improved Handling: H&R Springs lower the center of gravity, resulting in better cornering stability.
- Enhanced Stance: The lowered ride height gives your vehicle a more aggressive and sporty appearance.
- Quality Construction: Made from high-quality materials, H&R Springs are designed for durability and performance.
Tools and Materials Needed
Before starting the installation, ensure you have the following tools and materials ready:
- Jack and jack stands
- Socket set
- Wrench set
- Spring compressor
- Torque wrench
- H&R Springs for C63 M177
Step-by-Step Installation Guide
1. Prepare the Vehicle
Start by parking your C63 M177 on a flat surface. Engage the parking brake and loosen the wheel nuts on the front and rear wheels.
2. Lift the Vehicle
Using a jack, lift the front of the vehicle and secure it with jack stands. Repeat this process for the rear of the vehicle.
3. Remove the Wheels
Once the vehicle is securely lifted, remove the wheels to access the suspension components.
4. Remove the Old Springs
Using the socket and wrench set, carefully remove the bolts securing the strut assembly. Once the bolts are removed, use the spring compressor to safely decompress the old springs before removing them.
5. Install the H&R Springs
With the old springs removed, place the H&R Springs onto the strut assembly. Ensure they are seated correctly and reassemble the strut, following the reverse order of disassembly.
6. Reinstall the Strut Assembly
Once the new springs are installed, carefully reinstall the strut assembly back into the vehicle. Tighten the bolts to the manufacturer’s specifications using a torque wrench.
7. Repeat for the Rear Suspension
Follow the same steps to remove and replace the rear springs. Ensure all components are tightened properly before moving on.
8. Reinstall the Wheels
After both front and rear springs have been replaced, reinstall the wheels. Hand-tighten the wheel nuts before lowering the vehicle.
9. Lower the Vehicle
Carefully lower the vehicle back to the ground and remove the jack stands. Once on the ground, use the torque wrench to fully tighten the wheel nuts to the specified torque.
10. Test Drive
Finally, take your C63 M177 for a test drive to ensure everything is functioning correctly. Pay attention to the handling and ride quality, and check for any unusual noises.
Conclusion
Installing H&R Springs on your C63 M177 is a straightforward process that can be completed in under two hours. With improved handling and a more aggressive stance, your vehicle will not only look better but also perform better on the road.