Table of Contents
Installing a cold air intake is a popular modification for car enthusiasts looking to enhance performance. In this guide, we will walk you through the process of installing the Invidia Cold Air Intake on your BRZ FA24, which can boost your car’s power by 8-12 horsepower.
Tools and Materials Needed
- Invidia Cold Air Intake Kit
- Socket set (10mm and 12mm sockets)
- Ratchet and extension
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Torque wrench
- Shop towels
Preparation Steps
Before starting the installation, ensure that your vehicle is parked on a flat surface and the engine is cool. Gather all tools and materials to make the process smooth.
Step 1: Remove the Engine Cover
Using a socket wrench, remove the bolts securing the engine cover. Carefully lift the cover off and set it aside.
Step 2: Disconnect the Battery
To prevent any electrical issues, disconnect the negative terminal of the battery using a socket wrench.
Removing the Stock Air Intake
Step 3: Remove the Air Intake Duct
Loosen the clamps on the air intake duct using a flathead screwdriver. Carefully detach the duct from the throttle body and airbox.
Step 4: Disconnect the Mass Air Flow Sensor
Unplug the mass air flow (MAF) sensor connector by pressing the tab and pulling it out. Be gentle to avoid damaging the connector.
Step 5: Remove the Airbox
Unscrew the bolts holding the airbox in place using a socket wrench. Once loose, lift the airbox out of the engine bay.
Installing the Invidia Cold Air Intake
Step 6: Position the New Intake
Take the Invidia cold air intake and position it in the same location as the stock airbox. Ensure it fits snugly without any obstructions.
Step 7: Secure the Intake
Using the provided bolts and hardware, secure the new intake in place. Use a torque wrench to ensure the bolts are tightened to the manufacturer’s specifications.
Step 8: Reinstall the MAF Sensor
Plug the MAF sensor back into the new intake. Ensure the connector clicks into place securely.
Step 9: Attach the Intake Duct
Reconnect the intake duct to the throttle body and airbox. Tighten the clamps to ensure a secure fit.
Final Steps
Step 10: Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure it is tight and secure.
Step 11: Replace the Engine Cover
Place the engine cover back on and secure it with the bolts you removed earlier.
Step 12: Start the Engine
Start your vehicle and listen for any unusual sounds. Check for any air leaks around the intake area.
Conclusion
Congratulations! You have successfully installed the Invidia Cold Air Intake on your BRZ FA24. Enjoy the improved performance and the thrilling driving experience that comes with it.