Table of Contents
The Magnuson TVS2300 Supercharger is a popular upgrade for the GR86, enhancing performance and driving experience. This article provides a comprehensive, step-by-step guide to installing this supercharger on your GR86.
Tools and Materials Needed
- Magnuson TVS2300 Supercharger Kit
- Socket set
- Torque wrench
- Wrenches
- Screwdrivers
- Pliers
- Vacuum hose
- Coolant
- Oil
- Shop towels
Preparation Steps
Before starting the installation process, ensure you have a clean workspace. Gather all the necessary tools and materials listed above. It’s also recommended to review the installation manual provided with the Magnuson kit for any specific instructions.
Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
Remove the Engine Cover
Next, carefully remove the engine cover by unscrewing the bolts securing it in place. Set it aside in a safe location.
Removing the Stock Intake System
The next step involves removing the stock intake system, which will make way for the new supercharger.
Detach the Air Intake Hose
Loosen the clamps on the air intake hose and carefully detach it from the throttle body. Make sure to keep the clamps for reinstallation.
Remove the Stock Intake Manifold
Unbolt the intake manifold from the engine. Carefully lift it off and set it aside, ensuring no debris falls into the engine bay.
Installing the Magnuson TVS2300 Supercharger
With the stock components removed, you can now proceed to install the Magnuson TVS2300 Supercharger.
Position the Supercharger
Carefully position the supercharger onto the engine block, aligning it with the mounting holes. Ensure that the gasket is properly placed to prevent any leaks.
Secure the Supercharger
Using the provided bolts, secure the supercharger to the engine block. Use a torque wrench to tighten the bolts to the manufacturer’s specifications.
Reconnecting the Intake System
Once the supercharger is securely in place, you will need to reconnect the intake system.
Attach the Air Intake Hose
Reattach the air intake hose to the throttle body, ensuring that the clamps are tightened properly to prevent any air leaks.
Install the New Intake Manifold
Install the new intake manifold that comes with the Magnuson kit. Align it with the mounting holes and secure it using the provided bolts.
Final Steps
With the supercharger and intake system installed, there are a few final steps to complete before starting the engine.
Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure the connection is tight to avoid any issues during startup.
Check Fluid Levels
Check the coolant and oil levels, topping them off if necessary. This is crucial to ensure the engine runs smoothly after the installation.
Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual noises and check for leaks around the supercharger.
Conclusion
Installing the Magnuson TVS2300 Supercharger on your GR86 can significantly enhance its performance. By following these steps methodically, you can ensure a successful installation. Always refer to the manufacturer’s instructions for best practices and safety precautions.