Table of Contents
The Ram TRX is known for its impressive performance and rugged capabilities. However, for those looking to push the limits even further, installing a Rotrex C38 supercharger can provide the ultimate performance boost. This guide will walk you through the step-by-step process of installing the Rotrex C38 supercharger on your Ram TRX.
What You Will Need
- Rotrex C38 Supercharger Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Vacuum pump
- Cooling system tools
- Safety goggles and gloves
- Service manual for Ram TRX
Preparation
Before starting the installation, ensure that you have all the necessary tools and parts ready. It is also advisable to work in a well-ventilated area and wear appropriate safety gear.
Step 1: Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
Step 2: Remove the Engine Cover
Carefully remove the engine cover by unscrewing the bolts that secure it in place. Set the cover aside in a safe location.
Step 3: Remove the Intake Manifold
Next, detach the intake manifold by removing the bolts and disconnecting any sensors or hoses attached to it. This will provide access to the engine’s internals.
Installing the Rotrex C38 Supercharger
Step 4: Position the Supercharger
With the intake manifold removed, position the Rotrex C38 supercharger in the designated area. Ensure it aligns with the engine’s specifications as outlined in the installation manual.
Step 5: Secure the Supercharger
Using the provided bolts, secure the supercharger to the engine block. Refer to the torque specifications in your service manual to ensure proper tightness.
Step 6: Connect the Intake and Exhaust
Connect the intake and exhaust piping to the supercharger. Make sure all connections are tight and sealed to prevent any air leaks.
Finalizing the Installation
Step 7: Reinstall the Intake Manifold
Carefully reinstall the intake manifold, ensuring all sensors and hoses are reconnected properly. Secure it with the appropriate bolts.
Step 8: Reconnect the Battery
Reconnect the negative terminal of the battery. This will restore power to the vehicle’s electrical systems.
Step 9: Check for Leaks
Start the engine and allow it to idle. Check for any leaks around the supercharger and intake areas. If everything appears secure, proceed to the next step.
Tuning Your Ram TRX
After installing the Rotrex C38 supercharger, it is essential to tune your engine to maximize performance. This can be done using a professional tuning service or a compatible tuning device.
Conclusion
Installing a Rotrex C38 supercharger on your Ram TRX can significantly enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency.