Table of Contents
The Viper Venom Supercharger is a powerful upgrade for those looking to enhance the performance of their Dodge Viper. With the potential to push your vehicle to over 700 horsepower, this supercharger installation can transform your driving experience. This step-by-step guide will walk you through the installation process, ensuring that you can achieve maximum performance safely and effectively.
Tools and Materials Needed
- Viper Venom Supercharger Kit
- Socket Set
- Wrenches
- Torque Wrench
- Drill and Drill Bits
- Vacuum Pump
- Coolant
- Oil
- Rags and Cleaning Supplies
- Safety Glasses and Gloves
Preparation
Before starting the installation, ensure that your vehicle is parked on a level surface and that the engine is cool. Gather all necessary tools and materials, and read through the supercharger kit instructions thoroughly. This preparation will help streamline the installation process.
Step 1: Remove the Engine Cover
Begin by removing the engine cover of your Viper. This will give you access to the engine components necessary for the installation. Use your socket set to remove any bolts securing the cover in place.
Step 2: Disconnect the Battery
For safety, disconnect the negative terminal of the battery to prevent any electrical issues during the installation. Make sure to secure the terminal away from the battery.
Step 3: Remove the Intake Manifold
Next, you will need to remove the intake manifold. This involves disconnecting various hoses and electrical connectors. Take care to label any connections for easier reinstallation. Once everything is disconnected, use your wrench to remove the manifold bolts and lift the manifold off.
Step 4: Install the Supercharger Bracket
With the intake manifold out of the way, it’s time to install the supercharger bracket. Position the bracket according to the instructions provided in the kit. Ensure it is aligned correctly before securing it with bolts. Use a torque wrench to tighten the bolts to the specified torque settings.
Step 5: Mount the Supercharger
Now, carefully mount the supercharger onto the bracket. Ensure that all alignment pins are correctly seated. Once in place, secure the supercharger using the provided bolts, again utilizing the torque wrench to meet the required specifications.
Step 6: Reinstall the Intake Manifold
After the supercharger is mounted, it’s time to reinstall the intake manifold. Carefully lower it back into position, ensuring that all gaskets are correctly seated. Reconnect any hoses and electrical connectors that were previously removed, and secure the manifold with bolts, tightening them to the specified torque.
Step 7: Connect the Vacuum Lines
Connect the vacuum lines to the supercharger as per the installation instructions. Ensure that all connections are secure and free from leaks, as this can affect the performance of the supercharger.
Step 8: Reconnect the Battery
Once all components are secured, reconnect the negative terminal of the battery. This will restore power to the vehicle’s electrical systems.
Step 9: Fill with Coolant and Oil
Check the coolant levels and fill as necessary. Additionally, ensure that the engine oil is at the appropriate level, as the supercharger may require additional lubrication. Refer to the supercharger kit specifications for any specific oil requirements.
Step 10: Start the Engine
With everything reassembled, it’s time to start the engine. Listen for any unusual sounds and check for leaks around the supercharger and intake manifold. Allow the engine to idle for a few minutes to ensure everything is functioning properly.
Step 11: Test Drive
After confirming that there are no issues while idling, take your Viper for a test drive. Start slowly and gradually increase speed, paying attention to how the vehicle responds. This will help you gauge the performance of the supercharger and ensure that it is operating as intended.
Conclusion
Installing the Viper Venom Supercharger can significantly enhance your vehicle’s performance, pushing it to over 700 horsepower. By following this step-by-step guide, you can ensure a successful installation that maximizes your Viper’s capabilities. Always remember to consult the supercharger kit instructions for any specific requirements and safety precautions.