Table of Contents
Installing a Turbosmart anti-lag module can significantly enhance your vehicle’s performance, especially if you’re into motorsports or spirited driving. This guide will walk you through the process step-by-step, ensuring you can achieve this modification at home for approximately $1,200.
What is an Anti-lag Module?
An anti-lag module is designed to reduce turbo lag by keeping the turbocharger spooled even when the throttle is closed. This results in quicker acceleration and improved throttle response, making it a popular modification for performance enthusiasts.
Tools and Materials Needed
- Turbosmart anti-lag module kit
- Basic hand tools (screwdrivers, wrenches, pliers)
- Wire strippers and crimpers
- Electrical tape
- Heat shrink tubing
- Multimeter
- Safety goggles
- Gloves
Preparation Steps
Before starting the installation, ensure that you have a clean workspace and all necessary tools and materials ready. Read through the instruction manual provided with your Turbosmart module to familiarize yourself with the components.
Safety Precautions
Always wear safety goggles and gloves during the installation process to protect yourself from any potential hazards. Make sure the vehicle is parked on a flat surface and the engine is cool before proceeding.
Step-by-Step Installation
Step 1: Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during installation.
Step 2: Locate the Turbocharger
Identify the turbocharger in your vehicle. This is typically located near the engine and connected to the exhaust system. Refer to your vehicle’s manual if you have trouble locating it.
Step 3: Remove Necessary Components
You may need to remove certain components to access the turbocharger. This could include intake pipes or heat shields. Keep track of any bolts or screws you remove.
Step 4: Install the Anti-lag Module
Mount the Turbosmart anti-lag module in a suitable location, ensuring it is secure and away from any heat sources. Follow the instructions provided with the module for proper mounting techniques.
Step 5: Wiring Connections
Connect the wiring harness from the anti-lag module to your vehicle’s electrical system. This typically involves splicing into the ignition and throttle position sensor wires. Use wire strippers and crimpers to ensure secure connections.
Step 6: Reassemble Components
Once the wiring is complete, reassemble any components you removed earlier. Double-check that all bolts and screws are tightened properly.
Step 7: Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure that all tools are removed from the engine bay before starting the vehicle.
Step 8: Test the Installation
Start your vehicle and let it idle for a few minutes. Check for any unusual sounds or warning lights on the dashboard. If everything seems normal, take the car for a test drive to ensure the anti-lag module is functioning correctly.
Tuning the Anti-lag Module
After installation, you may need to tune the anti-lag module to achieve optimal performance. Refer to the manufacturer’s guidelines for tuning suggestions and adjustments.
Maintenance Tips
To ensure longevity and performance of your anti-lag module, consider the following maintenance tips:
- Regularly inspect wiring for wear and tear.
- Keep the module clean and free from debris.
- Check for software updates from Turbosmart.
- Monitor performance and address any issues promptly.
Conclusion
Installing a Turbosmart anti-lag module is a rewarding DIY project that can greatly enhance your vehicle’s performance. By following this guide, you can complete the installation with confidence and enjoy the benefits of reduced turbo lag.