Table of Contents
Installing a K-Tuned Short Throw Shifter in your Civic Si can significantly enhance your driving experience. This guide provides a detailed step-by-step process to help you through the installation.
Tools and Materials Needed
- K-Tuned Short Throw Shifter Kit
- Socket Set
- Ratchet Wrench
- Torque Wrench
- Screwdriver Set
- Grease
- Shop Towels
- Safety Glasses
Preparation Steps
Before starting the installation, ensure that your vehicle is parked on a flat surface and the engine is cool. Gather all the tools and materials listed above.
Step 1: Remove the Center Console
To access the shifter, you will need to remove the center console. Start by using a screwdriver to remove any screws holding the console in place.
Once the screws are removed, gently lift the console upwards to detach it from the clips. Be cautious not to damage any wiring connections.
Step 2: Disconnect the Shifter Cables
Locate the shifter cables connected to the factory shifter. Use a socket wrench to remove the bolts securing the cables. Carefully disconnect the cables from the shifter assembly.
Step 3: Remove the Factory Shifter
With the cables disconnected, you can now remove the factory shifter. Unscrew the bolts holding the shifter in place using a socket wrench. Once removed, pull the shifter out of the assembly.
Installing the K-Tuned Short Throw Shifter
Step 4: Prepare the New Shifter
Take the K-Tuned Short Throw Shifter out of the box. Apply a small amount of grease to the pivot points as recommended in the installation manual.
Step 5: Install the New Shifter
Insert the K-Tuned Short Throw Shifter into the shifter assembly. Ensure it is seated properly. Use the provided bolts to secure the shifter in place. Tighten them using a torque wrench to the specifications provided in the manual.
Step 6: Reconnect the Shifter Cables
Reconnect the shifter cables to the new shifter. Make sure the connections are secure. Adjust the cables as necessary to ensure smooth operation.
Final Steps
Step 7: Reinstall the Center Console
Carefully place the center console back into position. Align it with the clips and press down gently to secure it. Replace any screws that were removed earlier.
Step 8: Test the Shifter
Before taking your Civic Si for a drive, test the new shifter to ensure it operates smoothly. Move through all the gears to confirm proper installation.
Conclusion
With the K-Tuned Short Throw Shifter installed, you should notice a significant improvement in shifting performance. Enjoy your enhanced driving experience!