Rsx Turbo Kit Installation Guide: Installing the Garrett Gt3076r for 350+ Hp

by

The RSX is a popular choice for car enthusiasts looking to boost performance. Installing a turbo kit can significantly increase horsepower, and the Garrett GT3076R is one of the best options available for achieving over 350 HP. This guide will walk you through the installation process step by step.

Tools and Materials Needed

  • Garrett GT3076R Turbo Kit
  • Socket set
  • Wrenches
  • Torque wrench
  • Intercooler piping
  • Blow-off valve
  • Fuel pump and injectors
  • Vacuum lines
  • Oil feed and drain lines
  • Heat wrap
  • Gaskets and seals
  • Engine management system

Preparation

Before starting the installation, ensure that you have all the necessary tools and materials. It’s also important to prepare your workspace to make the process easier and more efficient.

Make sure your vehicle is parked on a flat surface and turn off the ignition. Disconnect the battery to avoid any electrical issues during the installation.

Removing the Stock Components

The first step in the installation process is to remove the stock components that will be replaced by the turbo kit.

  • Remove the intake manifold.
  • Take off the stock exhaust manifold.
  • Disconnect the stock fuel lines and injectors.
  • Remove the stock air intake system.
  • Take out the stock intercooler if applicable.

Installing the Turbo Kit

With the stock components removed, you can now begin the installation of the Garrett GT3076R turbo kit.

  • Install the new turbo manifold using the provided gaskets.
  • Attach the Garrett GT3076R turbo to the manifold.
  • Connect the oil feed and drain lines to the turbo.
  • Install the intercooler piping and connect it to the turbo outlet.
  • Install the blow-off valve on the piping.
  • Connect the new fuel injectors and fuel pump.

Connecting the Engine Management System

To ensure your engine runs efficiently with the new turbo setup, you need to connect an engine management system.

  • Install the engine management software on your laptop or PC.
  • Connect the system to your vehicle’s OBD-II port.
  • Configure the settings according to the turbo kit specifications.
  • Upload the new tune to the ECU.

Final Steps

After everything is installed and connected, it’s time to put everything back together and check your work.

  • Reinstall the intake manifold and any remaining components.
  • Double-check all connections and fittings.
  • Reconnect the battery.
  • Start the engine and check for leaks.
  • Monitor the engine’s performance and make adjustments as necessary.

Conclusion

Installing the Garrett GT3076R turbo kit on your RSX can significantly enhance its performance, allowing you to achieve over 350 HP. By following this guide, you can ensure a successful installation and enjoy the thrill of boosted power.