Stage 3 Spec Aluminum Flywheel Installation: Achieve Smoother Revving and 12 Horsepower Gains

by

The Stage 3 SPEC Aluminum Flywheel is designed to enhance performance in high-performance vehicles. This article will guide you through the installation process, ensuring you achieve smoother revving and an impressive 12 horsepower gain.

Understanding the Benefits of an Aluminum Flywheel

Before diving into the installation, it’s crucial to understand the benefits that an aluminum flywheel brings to your vehicle:

  • Weight Reduction: Aluminum flywheels are significantly lighter than their steel counterparts, reducing rotational mass.
  • Improved Throttle Response: The reduced weight allows for quicker engine revs, enhancing throttle response.
  • Increased Horsepower: A lighter flywheel can lead to gains in horsepower, typically around 12 HP.

Tools Required for Installation

Gather the following tools before starting the installation process:

  • Socket set
  • Torque wrench
  • Flywheel puller
  • Clutch alignment tool
  • Safety glasses
  • Mechanic’s gloves

Step-by-Step Installation Process

Step 1: Prepare Your Vehicle

Begin by ensuring your vehicle is on a flat surface. Engage the parking brake and disconnect the negative battery terminal to prevent electrical issues during installation.

Step 2: Remove the Transmission

To access the flywheel, you will need to remove the transmission. Follow these steps:

  • Remove the driveshaft and any other components obstructing the transmission.
  • Unbolt the transmission from the engine block.
  • Carefully lower the transmission and set it aside.

Step 3: Remove the Old Flywheel

With the transmission removed, you can now access the flywheel. Follow these steps:

  • Use a flywheel puller to detach the old flywheel from the crankshaft.
  • Inspect the crankshaft for any damage or wear.

Step 4: Install the SPEC Aluminum Flywheel

Now it’s time to install the new aluminum flywheel:

  • Align the new flywheel with the crankshaft and secure it in place.
  • Tighten the flywheel bolts to the manufacturer’s specified torque settings.

Step 5: Reinstall the Clutch

With the flywheel installed, you can now reinstall the clutch:

  • Use a clutch alignment tool to position the clutch disc correctly.
  • Secure the clutch pressure plate to the flywheel with the appropriate bolts.

Step 6: Reattach the Transmission

Once the clutch is in place, reattach the transmission:

  • Lift the transmission back into position and align it with the engine block.
  • Secure the transmission with bolts, ensuring everything is tightly fastened.

Step 7: Final Checks

Before finishing up, perform the following checks:

  • Reconnect the driveshaft and any other components removed earlier.
  • Reconnect the negative battery terminal.

Testing Your Installation

After completing the installation, it’s essential to test the vehicle to ensure everything is functioning correctly:

  • Start the engine and listen for any unusual noises.
  • Test the throttle response to confirm smoother revving.
  • Perform a test drive to feel the horsepower gains.

Conclusion

The installation of a Stage 3 SPEC Aluminum Flywheel can significantly enhance your vehicle’s performance. By following this guide, you can achieve smoother revving and enjoy the benefits of increased horsepower. Always ensure to follow safety protocols and consult a professional if you are unsure about any step in the process.