Table of Contents
The Mitsubishi Lancer Evolution is a beloved car among enthusiasts, known for its performance and tuning potential. One popular modification is the installation of the Kompressor Two-step Launch Control, which can enhance your vehicle’s acceleration off the line. This step-by-step guide will walk you through the installation process.
What You Will Need
- Kompressor Two-step Launch Control Kit
- Basic hand tools (screwdrivers, wrenches, etc.)
- Wire strippers and connectors
- Electrical tape
- Multimeter
- Safety glasses
Preparation
Before starting the installation, ensure you have a clean workspace and all necessary tools at hand. It’s important to disconnect the battery to avoid any electrical issues during the installation process.
Step 1: Locate the ECU
The first step is to locate the Engine Control Unit (ECU) of your Mitsubishi Lancer Evolution. This is usually found under the dashboard on the driver’s side. You may need to remove some panels for better access.
Step 2: Connect the Launch Control Module
Once you have access to the ECU, take the Kompressor Launch Control module and connect it to the appropriate wires as per the instruction manual. Typically, you will connect to the RPM signal wire and the ignition signal wire.
Wiring Connections
- Identify the RPM signal wire (usually a green wire).
- Connect the module’s RPM wire to the ECU’s RPM signal wire.
- Identify the ignition signal wire (usually a yellow wire).
- Connect the module’s ignition wire to the ECU’s ignition wire.
Step 3: Mount the Control Switch
The next step is to mount the control switch inside the car. Choose a location that is easily accessible while driving, such as near the gear shifter or on the dashboard. Use the provided screws or adhesive to secure the switch.
Step 4: Connect the Control Switch
After mounting the control switch, run the wires from the switch to the launch control module. Ensure that the connections are secure and insulated with electrical tape to prevent any shorts.
Step 5: Reconnect the Battery
Once all connections are made, carefully reconnect the battery. Check for any loose wires or potential issues before proceeding.
Step 6: Test the System
With everything connected, it’s time to test the launch control system. Start your vehicle and activate the launch control switch. You should hear a beep or see an indicator light confirming the system is active.
Step 7: Fine-Tuning
After confirming the system works, you may need to fine-tune the settings according to your preferences. Refer to the Kompressor manual for specific adjustments related to RPM settings and launch parameters.
Step 8: Final Checks
Before taking your Mitsubishi Lancer Evolution for a test drive, double-check all connections and ensure everything is securely fastened. Safety should always be your top priority.
Conclusion
Installing the Kompressor Two-step Launch Control on your Mitsubishi Lancer Evolution can significantly improve your launch performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the enhanced driving experience.