Table of Contents
Installing an Edelbrock Performer Intake on your Chevelle SS can significantly enhance its performance. This guide will walk you through the step-by-step process to ensure a successful installation.
Tools and Materials Needed
- Edelbrock Performer Intake manifold
- Intake manifold gasket set
- Torque wrench
- Socket and ratchet set
- Flathead and Phillips screwdrivers
- Engine oil
- Rags for cleanup
Preparation Steps
Before starting the installation, it is crucial to prepare your workspace and the vehicle. Follow these steps:
- Ensure the engine is cool and the vehicle is parked on a level surface.
- Disconnect the negative battery cable to prevent any electrical issues.
- Remove any components obstructing the intake manifold, such as the air cleaner and carburetor.
Removing the Old Intake Manifold
To install the new Edelbrock Performer Intake, you must first remove the existing manifold. Follow these steps:
- Unbolt the old intake manifold using a socket and ratchet.
- Carefully lift the manifold off the engine, ensuring no debris falls into the intake ports.
- Clean the surface of the engine block to remove old gasket material and debris.
Installing the Edelbrock Performer Intake
Now that the old manifold is removed, you can proceed with the installation of the new Edelbrock Performer Intake. Follow these steps:
- Apply a thin layer of engine oil to the new intake manifold gaskets for a better seal.
- Position the new Edelbrock Performer Intake over the engine block.
- Align the bolt holes and gently lower the manifold onto the gaskets.
Securing the Intake Manifold
Once the intake is in place, it is essential to secure it properly. Follow these steps:
- Insert the intake manifold bolts and hand-tighten them to secure the manifold.
- Using a torque wrench, tighten the bolts in the recommended sequence to the specified torque setting.
- Double-check each bolt to ensure they are properly secured.
Reconnecting Components
After securing the intake manifold, it is time to reconnect all previously removed components. Follow these steps:
- Reattach the carburetor to the new intake manifold.
- Reconnect any vacuum lines and electrical connections that were removed.
- Install the air cleaner assembly back onto the carburetor.
Final Steps
With everything reconnected, follow these final steps to complete the installation:
- Reconnect the negative battery cable.
- Start the engine and check for any leaks around the intake manifold.
- Allow the engine to reach operating temperature and ensure everything is functioning correctly.
Troubleshooting Common Issues
If you encounter any issues after installation, consider the following troubleshooting tips:
- Check for vacuum leaks by inspecting all connections and hoses.
- Ensure that all bolts are torqued to the proper specifications.
- Verify that the carburetor is properly adjusted for the new intake manifold.
Conclusion
Installing an Edelbrock Performer Intake on your Chevelle SS can provide noticeable performance improvements. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your upgraded engine.