Step-by-step Guide to Installing a Edelbrock Performer Rpm on Your Mopar 440

by

Installing an Edelbrock Performer RPM intake manifold on your Mopar 440 can significantly enhance your engine’s performance. This step-by-step guide will walk you through the installation process, ensuring you achieve optimal results while maintaining safety and efficiency.

Tools and Materials Needed

  • Edelbrock Performer RPM intake manifold
  • Gasket set
  • Torque wrench
  • Socket set
  • Ratchet
  • Scraper
  • Engine degreaser
  • Shop towels
  • Thread sealant

Preparation Steps

Before you begin the installation, it is essential to prepare your workspace and the engine. Follow these preparation steps:

  • Ensure the engine is cool to the touch.
  • Disconnect the battery to prevent any electrical issues.
  • Remove any components obstructing access to the intake manifold, including the air cleaner and carburetor.
  • Clean the existing intake surface with an engine degreaser and scraper to remove old gaskets and debris.

Removing the Old Intake Manifold

With your workspace prepared, you can now remove the old intake manifold. Follow these steps:

  • Using a socket set, remove the bolts securing the old manifold to the engine.
  • Carefully lift the old manifold off the engine, taking care not to damage any surrounding components.
  • Inspect the gaskets and surfaces for any damage that may require additional cleaning or repair.

Installing the Edelbrock Performer RPM Intake Manifold

Now that the old manifold is removed, it’s time to install the new Edelbrock Performer RPM. Follow these steps closely:

  • Place the new gaskets onto the engine, ensuring they align properly with the intake ports.
  • Carefully lower the Edelbrock Performer RPM intake manifold onto the gaskets.
  • Start threading the intake bolts by hand to avoid cross-threading.
  • Using a torque wrench, tighten the bolts in a crisscross pattern to the manufacturer’s specifications, ensuring even pressure.

Reconnecting Components

After the manifold is securely installed, you will need to reconnect various components:

  • Reinstall the carburetor, ensuring the gasket is in place to prevent leaks.
  • Reconnect the air cleaner and any other components that were removed during the preparation phase.
  • Double-check all connections for tightness and proper alignment.

Final Checks and Testing

Before starting the engine, it’s crucial to perform final checks:

  • Reconnect the battery and ensure all electrical connections are secure.
  • Check for any fuel leaks around the carburetor and intake manifold.
  • Start the engine and allow it to idle for a few minutes, monitoring for any unusual noises or leaks.
  • Take the vehicle for a test drive to evaluate performance and ensure everything is functioning correctly.

Conclusion

Installing an Edelbrock Performer RPM intake manifold on your Mopar 440 can enhance your engine’s performance significantly. By following this step-by-step guide, you can ensure a successful installation that boosts your vehicle’s capabilities. Always remember to work safely and consult with professionals if you encounter any challenges.