Table of Contents
Installing a Garrett Turbo Kit on your Acura TLX Type S can significantly enhance your vehicle’s performance. This step-by-step guide will walk you through the entire process, ensuring a smooth installation and optimal results.
Tools and Materials Needed
- Garrett Turbo Kit
- Socket set
- Wrenches
- Torque wrench
- Jack and jack stands
- Oil catch pan
- Coolant
- New gaskets
- Vacuum lines
- Intercooler piping
Preparation Steps
Before beginning the installation, ensure that you have all the necessary tools and materials at hand. Also, park your Acura TLX Type S on a level surface and engage the parking brake.
Disconnect the Battery
Start by disconnecting the negative terminal of the battery to prevent any electrical issues during the installation process.
Drain Fluids
Next, drain the engine oil and coolant. Use an oil catch pan to collect the fluids and dispose of them properly.
Removing the Stock Components
With the preparation complete, you can now begin removing the stock components of your Acura TLX Type S.
Remove the Engine Cover
Start by removing the engine cover. This may require unscrewing several bolts or clips. Keep these fasteners in a safe place for reinstallation.
Disconnect the Intake System
Next, disconnect the intake system from the throttle body. This includes removing the air filter box and any associated piping.
Remove Exhaust Components
Now, you will need to remove the exhaust manifold. This typically involves unbolting the manifold from the engine and disconnecting the exhaust downpipe.
Installing the Garrett Turbo Kit
With the stock components removed, it’s time to install the Garrett Turbo Kit.
Install the Turbocharger
Begin by positioning the turbocharger onto the exhaust manifold. Ensure that the gasket is properly placed to avoid leaks, and then secure it using the provided bolts.
Connect the Intercooler Piping
Next, connect the intercooler piping to the turbocharger and the throttle body. Make sure all connections are tight and secure to prevent any boost leaks.
Install the Oil and Coolant Lines
Attach the oil and coolant lines to the turbocharger. Ensure that these connections are properly tightened to avoid any leaks.
Final Steps
With the turbo kit installed, you can now complete the final steps of the installation process.
Reinstall the Engine Cover
Replace the engine cover and secure it with the bolts or clips you previously removed.
Reconnect the Battery
Reconnect the negative terminal of the battery, ensuring a secure connection.
Refill Engine Oil and Coolant
Refill the engine oil and coolant to their respective levels. Check for any leaks around the turbocharger and associated components.
Testing Your Installation
After completing the installation, it’s essential to test your vehicle to ensure everything is functioning correctly.
Start the Engine
Start your Acura TLX Type S and let it idle for a few minutes. Monitor the oil pressure and coolant temperature to ensure they are within normal ranges.
Check for Leaks
Inspect the turbocharger and all connected lines for any signs of leaks. Address any issues immediately.
Take a Test Drive
Finally, take your Acura TLX Type S for a test drive. Pay attention to the performance and any unusual sounds that may indicate a problem.
Conclusion
Installing a Garrett Turbo Kit on your Acura TLX Type S can greatly enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency.