Step-by-step Guide to Installing a Hks F-con V Pro on the Mitsubishi 3000gt for Better Power

by

Installing a HKS F-Con V Pro on your Mitsubishi 3000GT can significantly enhance its performance. This step-by-step guide will walk you through the installation process, ensuring you achieve better power and efficiency from your vehicle.

What You Will Need

  • HKS F-Con V Pro unit
  • Wiring harness
  • Basic hand tools (screwdrivers, wrenches)
  • Socket set
  • Electrical tape
  • Multimeter
  • Safety glasses

Preparation Steps

Before you begin the installation, make sure to take the necessary precautions to ensure safety and efficiency. Follow these preparation steps:

  • Disconnect the battery to prevent any electrical shorts.
  • Gather all tools and components in a clean workspace.
  • Read the HKS F-Con V Pro manual thoroughly to understand the wiring and installation process.

Step 1: Remove the ECU

To install the HKS F-Con V Pro, you will first need to access the vehicle’s ECU. Follow these steps:

  • Locate the ECU in the driver’s side footwell.
  • Remove the panel covering the ECU by unscrewing it.
  • Disconnect the wiring harness from the ECU carefully.

Step 2: Connect the HKS F-Con V Pro Wiring Harness

Once the ECU is removed, you can begin connecting the HKS F-Con V Pro wiring harness:

  • Connect the HKS wiring harness to the ECU plug.
  • Ensure all connections are secure and properly aligned.
  • Use electrical tape to insulate any exposed wires to prevent shorts.

Step 3: Install the HKS F-Con V Pro Unit

Now it’s time to install the HKS F-Con V Pro unit itself:

  • Find a suitable location for the HKS unit, typically under the dashboard or in the engine bay.
  • Secure the unit using screws or mounting brackets provided.
  • Make sure the unit is easily accessible for future adjustments.

Step 4: Reconnect the ECU

After installing the HKS unit, you will need to reconnect the ECU:

  • Reconnect the wiring harness to the ECU.
  • Ensure all connections are tight and secure.
  • Replace the panel covering the ECU.

Step 5: Reconnect the Battery

With everything connected, it’s time to reconnect the battery:

  • Reconnect the negative terminal first, followed by the positive terminal.
  • Check for any loose connections or exposed wires.

Step 6: Configure the HKS F-Con V Pro

Once the installation is complete, you will need to configure the HKS F-Con V Pro:

  • Turn on the ignition without starting the engine.
  • Access the HKS F-Con setup menu using the provided software or interface.
  • Follow the on-screen instructions to configure settings according to your vehicle’s requirements.

Step 7: Test the Installation

After configuration, it’s crucial to test the installation:

  • Start the engine and listen for any unusual noises.
  • Check for warning lights on the dashboard.
  • Take the vehicle for a test drive to ensure everything is functioning correctly.

Troubleshooting Tips

If you encounter issues during or after installation, consider the following troubleshooting tips:

  • Double-check all wiring connections for security and integrity.
  • Ensure the HKS unit is properly grounded.
  • Consult the manual for specific error codes or troubleshooting steps.

Conclusion

Installing the HKS F-Con V Pro on your Mitsubishi 3000GT can lead to significant performance improvements. By following this step-by-step guide, you can ensure a successful installation and enjoy the enhanced power and efficiency of your vehicle.