Table of Contents
The Mitsubishi Evo is a beloved vehicle among car enthusiasts, known for its performance and tuning potential. One of the most effective upgrades for enhancing performance is the installation of a supercharger. In this guide, we will walk you through the step-by-step process of installing an HKS GT Supercharger on your Mitsubishi Evo.
Tools and Materials Needed
- HKS GT Supercharger Kit
- Socket set
- Torque wrench
- Screwdrivers (flathead and Phillips)
- Wrenches
- Hoses and clamps
- Engine oil
- Coolant
- Safety goggles
- Gloves
Preparation
Before starting the installation, ensure you have all the necessary tools and materials. Make sure your workspace is clean and organized. It’s also advisable to read the HKS installation manual thoroughly for specific instructions related to your supercharger model.
Step 1: Disconnect the Battery
Safety first! Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
Step 2: Remove the Existing Intake System
Next, you will need to remove the existing intake system. This includes the air filter, intake pipe, and throttle body. Use your socket set and wrenches to carefully detach these components. Keep track of all screws and clamps for reinstallation.
Step 3: Prepare the Supercharger Mounting Area
Once the intake system is removed, clean the mounting area to ensure a proper seal for the supercharger. Inspect the area for any debris or old gasket material that may interfere with installation.
Step 4: Install the Supercharger Bracket
Follow the HKS manual to install the supercharger bracket onto the engine. Use the provided bolts and ensure they are tightened to the specified torque settings. This bracket will support the supercharger in its final position.
Step 5: Mount the Supercharger
With the bracket securely in place, carefully mount the HKS GT Supercharger onto the bracket. Align it properly and use the provided hardware to secure it. Double-check all connections to ensure everything is tight and secure.
Step 6: Connect the Intake Piping
Next, connect the intake piping to the supercharger. Ensure that all hoses and clamps are properly fitted to prevent any leaks. It’s important that the intake path is as smooth as possible for optimal performance.
Step 7: Install the Intercooler (if applicable)
If your HKS GT Supercharger kit includes an intercooler, now is the time to install it. Follow the specific instructions provided in the kit to ensure correct placement and function. This component is crucial for maintaining optimal air temperatures.
Step 8: Reconnect the Throttle Body
After the supercharger and intake piping are installed, reconnect the throttle body. Ensure that all connections are tight and that there are no air leaks. This step is vital for maintaining engine performance.
Step 9: Refill Fluids
Before starting the engine, refill the engine oil and coolant as needed. Check the HKS manual for any specific fluid requirements related to the supercharger installation.
Step 10: Reconnect the Battery
With everything installed and fluids refilled, reconnect the negative terminal of the battery. This will allow you to power the vehicle and check for any issues.
Step 11: Start the Engine
Now it’s time to start the engine. Listen for any unusual noises and check for leaks around the supercharger and intake areas. If everything sounds good, let the engine idle for a few minutes.
Step 12: Test Drive
After letting the engine idle, take your Mitsubishi Evo for a test drive. Monitor the performance and ensure that the supercharger is functioning as expected. Pay attention to the throttle response and overall power delivery.
Conclusion
Installing an HKS GT Supercharger on your Mitsubishi Evo can significantly enhance its performance. By following this step-by-step guide, you can ensure a successful installation. Always remember to consult the HKS manual for any specific details related to your supercharger model. Happy tuning!