Table of Contents
The Honda S2000 AP1 is a beloved sports car known for its high-revving engine and exceptional handling. One of the best upgrades for enhancing its performance is installing a Hondata FlashPro. This guide will walk you through the step-by-step process of installing a Hondata FlashPro on your S2000 AP1, resulting in better power and throttle response.
What You Will Need
- Hondata FlashPro unit
- OBDII connector cable
- Laptop or PC with FlashPro Manager software
- Basic hand tools (screwdrivers, wrenches)
- Access to a stable internet connection for software updates
Step 1: Preparing Your Vehicle
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is turned off. Gather all the necessary tools and equipment.
Disconnecting the Battery
For safety, disconnect the negative terminal of the battery. This will prevent any electrical shorts during the installation process.
Step 2: Installing the Hondata FlashPro
Locate the OBDII port in your S2000, which is usually found under the dashboard near the steering column. Plug the Hondata FlashPro unit into this port.
Securing the FlashPro
Make sure the FlashPro is securely connected and does not obstruct any pedals or controls. You may use zip ties to keep it in place if necessary.
Step 3: Installing FlashPro Manager Software
Download the FlashPro Manager software from the Hondata website. Follow the installation instructions specific to your operating system (Windows or Mac).
Connecting the FlashPro to Your Computer
Using the OBDII connector cable, connect the FlashPro to your laptop or PC. Launch the FlashPro Manager software to begin the setup process.
Step 4: Updating the Firmware
Check for any firmware updates in the FlashPro Manager. If updates are available, follow the prompts to install them. This step is crucial for ensuring optimal performance.
Step 5: Uploading a Base Map
Once the firmware is updated, select a base map that suits your vehicle’s modifications and intended use. The FlashPro Manager provides various options tailored to different setups.
Saving Your Configuration
After selecting the base map, save your configuration before uploading it to the FlashPro. This ensures you have a backup if needed.
Step 6: Uploading the Map to the ECU
With everything set, upload the selected map to your S2000’s ECU through the FlashPro Manager. This process may take a few minutes, so be patient.
Step 7: Finalizing the Installation
Once the upload is complete, disconnect the FlashPro from your computer and the OBDII port. Reconnect the negative battery terminal to restore power to your vehicle.
Testing Your Vehicle
Start your S2000 and allow it to idle for a few minutes. Take it for a test drive to experience the improved power and throttle response. Pay attention to any unusual sounds or behaviors.
Step 8: Fine-Tuning and Adjustments
If necessary, return to the FlashPro Manager to make any fine-tuning adjustments based on your driving experience. This may include modifying fuel maps or ignition timing.
Consulting with Professionals
If you are unsure about any adjustments, consider consulting with a tuning professional to optimize your settings for maximum performance.
Conclusion
Installing a Hondata FlashPro on your S2000 AP1 can significantly enhance your driving experience by improving power and throttle response. By following this step-by-step guide, you can confidently complete the installation and enjoy the benefits of a well-tuned vehicle.