Step-by-step Guide to Installing a H&r Lowering Kit on Your Macan Turbo

by

Installing a H&R lowering kit on your Macan Turbo can enhance both its appearance and performance. This step-by-step guide will walk you through the installation process, ensuring you have all the necessary information to complete the task safely and effectively.

Tools and Materials Needed

  • H&R Lowering Kit
  • Jack and jack stands
  • Socket set
  • Torque wrench
  • Spring compressor
  • Flathead screwdriver
  • Phillips screwdriver
  • Safety glasses
  • Gloves

Safety Precautions

Before starting the installation, ensure you take the necessary safety precautions:

  • Wear safety glasses and gloves.
  • Work in a well-ventilated area.
  • Ensure the vehicle is on a flat surface.
  • Use jack stands to support the vehicle securely.

Step 1: Prepare the Vehicle

Start by parking your Macan Turbo on a flat surface and applying the parking brake. Gather all your tools and materials to have them ready for the installation.

Next, loosen the lug nuts on the front wheels before lifting the vehicle. This will make it easier to remove the wheels later.

Step 2: Lift the Vehicle

Using a jack, lift the front of the vehicle and place jack stands under the frame to secure it. Repeat this process for the rear of the vehicle.

Step 3: Remove the Wheels

Once the vehicle is securely lifted, remove the lug nuts completely and take off the front and rear wheels. Set them aside in a safe location.

Step 4: Remove the Stock Springs

To access the stock springs, you will need to remove the struts. Start by disconnecting any components that may obstruct the strut removal, such as brake lines or sway bar links.

Next, use a spring compressor to safely compress the stock springs while they are still attached to the strut. Once compressed, remove the top nut of the strut and carefully detach the spring from the strut assembly.

Step 5: Install the H&R Lowering Springs

With the stock springs removed, it’s time to install the H&R lowering springs. Place the lowering spring onto the strut assembly, ensuring it is seated properly.

Reattach the top nut to secure the spring in place. Make sure to torque it to the manufacturer’s specifications.

Step 6: Reinstall the Struts

Carefully reinstall the struts with the new lowering springs back into the vehicle. Reconnect any components you had to remove earlier, such as brake lines and sway bar links.

Step 7: Replace the Wheels

Once the struts are securely reinstalled, it’s time to put the wheels back on. Align the wheels with the hub and hand-tighten the lug nuts.

Step 8: Lower the Vehicle

Carefully lower the vehicle back to the ground using the jack. Once the vehicle is on the ground, use a torque wrench to tighten the lug nuts to the proper specifications.

Step 9: Test Drive and Adjustment

After completing the installation, take your Macan Turbo for a test drive. Pay attention to the handling and ride quality. If necessary, make adjustments to the suspension settings based on your preferences.

Conclusion

Installing a H&R lowering kit on your Macan Turbo can significantly improve its aesthetics and performance. By following this step-by-step guide, you can ensure a successful installation. Always remember to prioritize safety and consult a professional if you are unsure about any steps in the process.