Table of Contents
Installing a K&N short ram intake on your Mitsubishi Eclipse can enhance your vehicle’s performance and improve engine efficiency. This step-by-step guide will walk you through the installation process, ensuring that you achieve optimal results.
What You Will Need
- K&N short ram intake kit
- Socket wrench set
- Flathead screwdriver
- Phillips screwdriver
- Ratchet
- Torque wrench
- Clean cloth
- Safety goggles
Before starting the installation, gather all necessary tools and parts. Make sure you have a clean workspace and wear safety goggles to protect your eyes.
Step 1: Prepare Your Vehicle
Begin by ensuring that your Mitsubishi Eclipse is parked on a flat surface and the engine is cool. Disconnect the negative battery terminal to prevent any electrical issues during the installation.
Step 2: Remove the Stock Intake System
Locate the stock air intake system. It typically consists of an airbox and a series of hoses. Use a socket wrench to remove the screws securing the airbox cover. Carefully lift the cover off and set it aside.
Next, disconnect any hoses attached to the air intake system. Use a flathead screwdriver to gently pry off any clamps holding the hoses in place. Once all hoses are disconnected, remove the entire airbox assembly by unscrewing any remaining bolts.
Step 3: Install the K&N Short Ram Intake
Take the K&N short ram intake out of the box and review the installation instructions provided by the manufacturer. Begin by attaching the heat shield to the intake tube using the provided hardware. Ensure that it is securely fastened.
Next, insert the intake tube into the throttle body. Make sure it fits snugly. Use the provided clamps to secure the intake tube in place. Tighten the clamps with a ratchet to ensure there are no air leaks.
Step 4: Reconnect Hoses and Wiring
Reconnect any hoses that were previously disconnected from the stock intake system. Make sure to secure them with clamps. If your K&N intake has any sensors, ensure they are properly connected to the intake tube.
Step 5: Finalize the Installation
Double-check all connections and ensure that everything is tightened properly. Reinstall any components that were removed during the installation process. This may include the engine cover or other parts that obstruct access to the intake.
Step 6: Reconnect the Battery and Test Drive
Reconnect the negative battery terminal and start the engine. Allow it to idle for a few minutes to ensure everything is functioning correctly. Listen for any unusual sounds that might indicate a problem.
After confirming that the installation was successful, take your Mitsubishi Eclipse for a test drive. Pay attention to the throttle response and overall performance. You should notice an improvement in acceleration and engine sound.
Maintenance Tips
- Regularly check the K&N filter for dirt and debris.
- Clean the filter according to the manufacturer’s recommendations.
- Inspect connections periodically to ensure they remain tight.
- Monitor engine performance for any changes.
By following these steps, you can successfully install a K&N short ram intake on your Mitsubishi Eclipse. Enjoy the enhanced performance and improved driving experience!