Step-by-step Guide to Installing a Macht Schnell Cold Air Intake on the W205 C63

by

Installing a Macht Schnell Cold Air Intake on your W205 C63 can significantly enhance your vehicle’s performance. This step-by-step guide will walk you through the installation process, ensuring that you can complete the task efficiently and effectively.

Tools and Materials Needed

  • Socket set
  • Ratchet
  • Torque wrench
  • Flathead screwdriver
  • Phillips screwdriver
  • New Macht Schnell Cold Air Intake kit
  • Shop towel
  • Safety glasses

Preparation

Before you begin the installation process, ensure that your vehicle is parked on a level surface and that the engine is cool. Gather all the necessary tools and materials listed above.

Step 1: Remove the Engine Cover

Using a socket set, remove the bolts securing the engine cover. Carefully lift the cover off and set it aside.

Step 2: Disconnect the Factory Air Intake

Locate the factory air intake system. Disconnect the mass airflow sensor connector by pressing the tab and pulling it off. Next, loosen the clamps securing the intake tube and remove the tube from the throttle body.

Step 3: Remove the Factory Air Box

Remove the bolts securing the factory air box to the chassis. Carefully lift the air box out of its location and set it aside.

Step 4: Install the Macht Schnell Cold Air Intake

Begin by placing the new Macht Schnell air filter into the intake housing. Secure it according to the manufacturer’s instructions. Next, connect the intake tube to the throttle body and tighten the clamps.

Step 5: Reconnect the Mass Airflow Sensor

Reconnect the mass airflow sensor connector that you disconnected earlier. Ensure that it clicks into place securely.

Step 6: Secure All Components

Double-check that all clamps and bolts are tightened properly. Ensure that there are no loose components in the installation.

Step 7: Replace the Engine Cover

Reinstall the engine cover by aligning it with the mounting points. Secure it with the bolts you removed earlier.

Step 8: Final Checks

Before starting the engine, perform a final inspection of all connections and ensure everything is securely in place. Check for any tools or materials left in the engine bay.

Step 9: Start the Engine

Start your vehicle and listen for any unusual sounds. Allow the engine to idle for a few minutes and check for any leaks around the intake system.

Conclusion

Congratulations! You have successfully installed a Macht Schnell Cold Air Intake on your W205 C63. Enjoy the enhanced performance and sound that comes with your new intake system.