Table of Contents
Installing a Mopar Performance TorqueFlite transmission in your B-body can significantly enhance your vehicle’s performance. This step-by-step guide will walk you through the installation process, ensuring you have a smooth and successful experience.
Tools and Materials Needed
- Mopar Performance TorqueFlite Transmission
- Transmission fluid
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Jack and jack stands
- Transmission cooler lines
- New gaskets and seals
- Safety glasses and gloves
Preparation
Before starting the installation, ensure your workspace is clean and organized. Gather all necessary tools and materials. Make sure the vehicle is on a flat surface and securely raised using a jack and jack stands.
Removing the Old Transmission
The first step in the installation process is to remove the old transmission. Follow these steps:
- Disconnect the battery to ensure safety.
- Remove the driveshaft by unbolting it from the rear axle and sliding it out of the transmission.
- Detach the transmission cooler lines and any electrical connections.
- Unbolt the transmission from the engine and the crossmember.
- Carefully lower the old transmission using a jack.
Preparing the New Transmission
Once the old transmission is removed, prepare the new Mopar Performance TorqueFlite transmission for installation:
- Inspect the new transmission for any damage or defects.
- Install new gaskets and seals to prevent leaks.
- Fill the transmission with the appropriate type and amount of transmission fluid.
Installing the New Transmission
With the new transmission prepared, it’s time to install it into the B-body:
- Using a jack, lift the new transmission into place.
- Align the transmission with the engine and secure it with bolts.
- Reattach the transmission crossmember and tighten the bolts to the manufacturer’s specifications.
- Reconnect the driveshaft, ensuring it is properly aligned.
- Reconnect the transmission cooler lines and electrical connections.
Final Steps
After installing the new transmission, complete the final steps to ensure everything is functioning correctly:
- Double-check all connections and bolts for tightness.
- Lower the vehicle back to the ground.
- Reconnect the battery.
- Start the engine and let it idle, checking for any leaks.
- Shift through all gears to ensure proper operation.
Conclusion
Installing a Mopar Performance TorqueFlite transmission in your B-body can greatly enhance your driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved performance.