Step-by-step Guide to Installing a Motive Gear Tracklocity Differential on a Mustang Gt

by

Installing a Motive Gear Tracklocity Differential on a Mustang GT can significantly enhance your vehicle’s performance. This guide will walk you through the step-by-step process to ensure a successful installation.

Tools and Materials Needed

  • Socket set
  • Torque wrench
  • Jack and jack stands
  • Diff cover gasket
  • Gear oil
  • New differential (Motive Gear Tracklocity)
  • Sealant
  • Safety glasses

Preparation

Before starting the installation, ensure the vehicle is parked on a flat surface. Engage the parking brake and wear safety glasses for protection.

Step 1: Lift the Vehicle

Using a jack, lift the rear of the Mustang GT and support it securely with jack stands. Make sure the vehicle is stable before proceeding.

Step 2: Remove the Rear Wheels

Remove the lug nuts and take off the rear wheels to access the differential.

Removing the Old Differential

Step 3: Drain the Gear Oil

Locate the differential drain plug and remove it to drain the gear oil into a suitable container. Allow it to fully drain before proceeding.

Step 4: Remove the Differential Cover

Unscrew the bolts securing the differential cover. Carefully pry it off, ensuring not to damage the mating surface. Clean the surface thoroughly.

Step 5: Remove the Old Differential

Unbolt the old differential from the housing. Carefully slide it out, taking note of any shims or spacers for reinstallation later.

Installing the Motive Gear Tracklocity Differential

Step 6: Prepare the New Differential

Before installation, ensure the Motive Gear Tracklocity Differential is clean and free of debris. Apply a light coat of gear oil to the gears for lubrication.

Step 7: Install the New Differential

Carefully slide the new differential into the housing, ensuring all shims and spacers are in their correct locations. Secure it with the bolts, tightening them to the manufacturer’s specifications.

Step 8: Reattach the Differential Cover

Apply sealant to the differential cover gasket and place it on the cover. Reattach the cover to the differential housing, tightening the bolts evenly.

Step 9: Refill with Gear Oil

Replace the drain plug and refill the differential with new gear oil through the fill hole. Ensure the oil level is correct according to the manufacturer’s recommendations.

Final Steps

Step 10: Reinstall the Rear Wheels

Put the rear wheels back on and hand-tighten the lug nuts. Lower the vehicle back to the ground.

Step 11: Tighten the Lug Nuts

Once the vehicle is on the ground, use a torque wrench to tighten the lug nuts to the specified torque setting.

Step 12: Test Drive

Take the Mustang GT for a test drive to ensure everything is functioning correctly. Listen for any unusual noises and check for leaks around the differential.

Conclusion

By following these steps, you can successfully install a Motive Gear Tracklocity Differential on your Mustang GT. Enjoy improved performance and handling on your drives!