Step-by-step Guide to Installing a Nameless Performance Cat-back Exhaust on the Fa20

by

Step-by-Step Guide to Installing a Nameless Performance Cat-back Exhaust on the FA20

The FA20 engine, known for its performance and tuning potential, can greatly benefit from an upgraded exhaust system. This guide will walk you through the installation of the Nameless Performance Cat-back exhaust, enhancing both the sound and performance of your vehicle.

Tools and Materials Needed

  • Nameless Performance Cat-back Exhaust Kit
  • Socket Set
  • Ratchet
  • Torque Wrench
  • Jack and Jack Stands
  • Safety Glasses
  • Gloves
  • Penetrating Oil

Preparation Steps

Before you start the installation, ensure that you have all the necessary tools and materials. It’s also important to work in a well-ventilated area and wear safety gear.

1. Lift the Vehicle

Using a jack, lift the vehicle and secure it with jack stands. Make sure the car is stable before crawling underneath.

2. Apply Penetrating Oil

Spray penetrating oil on the exhaust bolts to help loosen them. Allow it to sit for about 10-15 minutes.

Removing the Stock Exhaust

Now that the vehicle is prepared, you can begin removing the stock exhaust system.

1. Disconnect the Exhaust Hangars

Locate the exhaust hangars and use a pry bar or your hands to disconnect them from the rubber mounts. Be careful not to damage the hangars.

2. Remove the Exhaust Bolts

Using a socket set, remove the bolts connecting the exhaust to the exhaust manifold. Keep these bolts as you will need them for the new exhaust.

3. Take Out the Stock Exhaust

Once the bolts and hangars are disconnected, carefully remove the stock exhaust system from the vehicle. You may need an extra set of hands for this step.

Installing the Nameless Performance Cat-back Exhaust

With the stock exhaust removed, it’s time to install the new Nameless Performance Cat-back exhaust.

1. Position the New Exhaust

Align the new exhaust with the exhaust manifold and hang it in place using the hangars. Ensure it’s properly positioned before securing it.

2. Secure the Exhaust with Bolts

Using the original bolts, secure the new exhaust to the exhaust manifold. Make sure to torque them to the manufacturer’s specifications.

3. Reattach the Exhaust Hangars

Reconnect the exhaust hangars to the rubber mounts. Ensure they are secure and positioned correctly.

Final Checks

Once the installation is complete, it’s essential to perform a few final checks before lowering the vehicle.

1. Inspect for Leaks

Start the engine and listen for any exhaust leaks. If you hear any unusual sounds, check the connections and bolts.

2. Check for Clearance

Ensure that the exhaust has adequate clearance from the chassis and any other components to prevent contact during driving.

Conclusion

Installing a Nameless Performance Cat-back exhaust on your FA20 can significantly enhance your vehicle’s performance and sound. By following this step-by-step guide, you can achieve a successful installation and enjoy the benefits of your new exhaust system.