Table of Contents
Installing a Perrin Cold Air Intake on your BRZ FA20 can enhance your vehicle’s performance and efficiency. This step-by-step guide will walk you through the installation process, ensuring you have all the necessary tools and knowledge to complete the task successfully.
Tools and Materials Needed
- Socket wrench set
- Flathead screwdriver
- Torx screwdriver
- Ratchet
- Perrin Cold Air Intake kit
- Zip ties
- Cleaning cloths
Preparation Steps
Before you start the installation, make sure your vehicle is parked on a flat surface and the engine is cool. Gather all the tools and materials listed above to streamline the process.
1. Disconnect the Battery
To ensure safety, disconnect the negative terminal of the battery. This prevents any electrical shorts during the installation process.
2. Remove the Stock Air Intake
Begin by loosening the clamps on the stock air intake using your socket wrench. Carefully detach the intake from the throttle body and remove any connected sensors or hoses.
Once detached, remove the airbox by unscrewing any bolts or clips holding it in place. Keep these screws in a safe location for future use.
Installing the Perrin Cold Air Intake
Now that the stock intake is removed, it’s time to install the Perrin Cold Air Intake. Follow these steps carefully.
3. Assemble the Perrin Intake System
Unbox the Perrin Cold Air Intake kit and lay out all components. Refer to the instruction manual for the assembly order. Typically, you will connect the intake pipe to the air filter and ensure all fittings are secure.
4. Install the New Intake
Position the assembled Perrin intake system in the engine bay. Align it with the throttle body and ensure that it fits snugly without any obstructions.
Secure the intake pipe with the provided clamps and tighten them using your socket wrench. Make sure the air filter is positioned correctly to allow for optimal airflow.
Final Steps
With the new intake installed, it’s time to recheck all connections and ensure everything is properly secured.
5. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure the connection is tight to prevent any electrical issues.
6. Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual sounds that may indicate a loose connection or installation issue. Check for any leaks around the intake area.
Conclusion
Congratulations! You have successfully installed a Perrin Cold Air Intake on your BRZ FA20. Enjoy the enhanced performance and improved engine sound. Regularly check the intake system for any signs of wear or damage to maintain optimal performance.