Table of Contents
Installing a Perrin exhaust system on your BRZ FA20 can enhance your vehicle’s performance and sound. This step-by-step guide will walk you through the installation process, ensuring you have a smooth experience.
Tools and Materials Needed
- Jack and jack stands
- Socket set
- Wrenches
- Screwdriver set
- Perrin exhaust system
- Gasket and clamps (if not included)
- Safety glasses
- Gloves
Before starting the installation, make sure you have all the necessary tools and materials at hand. This will help streamline the process and prevent interruptions.
Preparation
Begin by preparing your workspace. Park your BRZ FA20 on a flat surface and engage the parking brake. Make sure the engine is cool before starting the installation.
Gather your tools and lay them out for easy access. Wear safety glasses and gloves to protect yourself during the installation.
Step 1: Lifting the Vehicle
Use a jack to lift the rear of your BRZ FA20. Once elevated, secure the vehicle with jack stands to ensure safety while you work underneath.
Step 2: Removing the Stock Exhaust System
Locate the stock exhaust system under your vehicle. Start by loosening the bolts securing the exhaust to the headers using a socket wrench. Be cautious, as some bolts may be rusted or difficult to remove.
Once the bolts are removed, disconnect the exhaust from the hangers. You may need to use a screwdriver to pry the hangers off the rubber mounts. Carefully lower the stock exhaust system and set it aside.
Step 3: Installing the Perrin Exhaust System
Begin the installation by positioning the Perrin exhaust system under your vehicle. Align it with the hangers and header connection points.
Secure the exhaust to the headers using the provided bolts. Ensure the gasket is properly placed to prevent leaks. Tighten the bolts securely but avoid overtightening, which could damage the components.
Next, attach the exhaust hangers to the rubber mounts. Make sure the exhaust is aligned correctly and does not touch any other components of the vehicle.
Step 4: Final Checks
Once the Perrin exhaust system is installed, double-check all connections and ensure everything is tight. Look for any signs of misalignment or contact with other parts.
Step 5: Lowering the Vehicle
Carefully remove the jack stands and lower your vehicle back to the ground using the jack. Ensure everything is secure before driving.
Step 6: Testing the Exhaust System
Start your engine and let it idle for a few minutes. Listen for any unusual sounds that may indicate a leak or improper installation. If everything sounds good, take your BRZ FA20 for a test drive to experience the new exhaust system.
Conclusion
Installing a Perrin exhaust system on your BRZ FA20 can be a rewarding project that enhances your vehicle’s performance and sound. By following this step-by-step guide, you can ensure a successful installation.
Always remember to perform regular checks on your exhaust system to maintain its performance and longevity. Enjoy the new sound and feel of your vehicle!