Table of Contents
Installing a RIPP Supercharger on your Charger can significantly enhance the performance of your vehicle. This guide will walk you through the step-by-step process to ensure a successful installation.
Tools and Materials Needed
- RIPP Supercharger Kit
- Socket Set
- Wrenches
- Torque Wrench
- Ratchet
- Drill with drill bits
- Engine Oil
- Coolant
- Safety Glasses
- Gloves
Preparation
Before starting the installation, ensure that you have all the necessary tools and materials at hand. It’s also essential to work in a well-ventilated area and wear safety gear for protection.
Step 1: Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical accidents during the installation process.
Step 2: Remove the Engine Cover
Using the socket set, carefully remove the bolts securing the engine cover and lift it off to expose the engine components.
Step 3: Remove the Factory Intake System
Detach the factory intake system by loosening the clamps and disconnecting any hoses. Make sure to keep all bolts and components for reinstallation.
Step 4: Install the RIPP Supercharger Bracket
Position the RIPP supercharger bracket onto the engine and secure it with the provided bolts. Use a torque wrench to ensure they are tightened to the specified torque settings.
Step 5: Mount the Supercharger
Carefully mount the RIPP supercharger onto the installed bracket. Make sure it is aligned properly and secure it using the supplied hardware.
Step 6: Connect the Intake Piping
Connect the intake piping to the supercharger and ensure all clamps are tightened. This step is crucial for preventing any air leaks.
Step 7: Install the Fuel System Upgrades
Follow the instructions provided in the RIPP kit to install any necessary fuel system upgrades, including new fuel injectors and fuel pump if applicable.
Step 8: Reconnect the Battery
Once all components are installed, reconnect the negative terminal of the battery. Double-check all connections and ensure everything is secure.
Final Steps
After the installation, it’s essential to check the fluid levels, including engine oil and coolant, before starting the engine. Make sure to follow the manufacturer’s recommendations for any additional setup or tuning required.
Step 9: Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual sounds and check for leaks around the installed components.
Step 10: Test Drive
Take your Charger for a test drive to ensure the supercharger is functioning correctly. Monitor the performance and responsiveness of the vehicle during the drive.
Conclusion
Installing a RIPP Supercharger on your Charger can greatly improve its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of enhanced power and efficiency.