Table of Contents
Installing a South Bend Evo Clutch can significantly enhance your vehicle’s response and performance. This step-by-step guide will walk you through the installation process to ensure you achieve optimal results.
Tools and Materials Needed
- South Bend Evo Clutch Kit
- Basic hand tools (wrenches, sockets, etc.)
- Torque wrench
- Jack and jack stands
- Clutch alignment tool
- Brake cleaner
- Rags
- Safety glasses
Preparation Steps
Before starting the installation, ensure you have a clean workspace and all necessary tools at hand. Follow these preparation steps:
- Park the vehicle on a flat surface.
- Disconnect the negative battery terminal.
- Lift the vehicle using a jack and secure it with jack stands.
Removing the Old Clutch
Follow these steps to remove the old clutch:
- Remove the transmission cover and any other components obstructing access to the clutch.
- Disconnect the clutch line and any electrical connections.
- Unbolt the transmission from the engine.
- Carefully slide the transmission away from the engine.
- Remove the old clutch pressure plate and disc from the flywheel.
Preparing the Flywheel
Before installing the new clutch, it’s essential to prepare the flywheel:
- Inspect the flywheel for any signs of wear or damage.
- Clean the flywheel surface with brake cleaner.
- If necessary, resurface the flywheel to ensure a smooth contact surface.
Installing the South Bend Evo Clutch
Now, you can install the new South Bend Evo Clutch. Follow these steps:
- Place the new clutch disc onto the flywheel, ensuring it is aligned correctly using the clutch alignment tool.
- Install the pressure plate over the clutch disc and hand-tighten the bolts.
- Using a torque wrench, tighten the pressure plate bolts to the manufacturer’s specifications.
Reinstalling the Transmission
After installing the clutch, it’s time to reinstall the transmission:
- Carefully slide the transmission back into place, aligning it with the engine.
- Reconnect the transmission bolts and tighten them to the specified torque.
- Reconnect the clutch line and any electrical connections.
- Reinstall any components that were removed for access.
Final Steps
Complete the installation process with these final steps:
- Reconnect the negative battery terminal.
- Lower the vehicle from the jack stands.
- Start the engine and check for any unusual noises or issues.
- Test the clutch operation by engaging and disengaging it several times.
Conclusion
By following this step-by-step guide, you can successfully install a South Bend Evo Clutch and improve your vehicle’s response. Regular maintenance and proper installation are key to enjoying the benefits of your new clutch.