Step-by-step Guide to Installing a Stage 2 Tuner Chip from Diablosport on Your Plymouth Road Runner

by

Installing a Stage 2 tuner chip from DiabloSport on your Plymouth Road Runner can significantly enhance your vehicle’s performance. This guide will walk you through the step-by-step process to ensure a successful installation.

Tools and Materials Needed

  • DiabloSport Stage 2 Tuner Chip
  • Socket wrench set
  • Screwdriver set
  • Wire strippers
  • Electrical tape
  • Safety glasses
  • Owner’s manual for Plymouth Road Runner

Preparation Steps

Before starting the installation, it’s important to prepare your workspace and vehicle. Follow these preparation steps:

  • Park your Plymouth Road Runner on a level surface.
  • Disconnect the negative battery terminal to prevent any electrical issues.
  • Gather all tools and materials in your workspace.
  • Read the owner’s manual for any specific instructions related to your vehicle model.

Locating the ECU

The Engine Control Unit (ECU) is the brain of your vehicle, and it is where the tuner chip will be installed. Here’s how to locate it:

  • Open the hood of your Road Runner.
  • Find the ECU, typically located near the engine bay on the driver’s side.
  • Refer to the owner’s manual for the exact location if needed.

Removing the ECU

Once you have located the ECU, follow these steps to remove it:

  • Use a socket wrench to remove the bolts securing the ECU in place.
  • Carefully disconnect the wiring harness by pressing the release tabs.
  • Lift the ECU out of the engine bay and place it on a clean, flat surface.

Installing the Stage 2 Tuner Chip

Now that you have the ECU removed, it’s time to install the DiabloSport Stage 2 tuner chip:

  • Locate the chip socket on the ECU.
  • Align the tuner chip with the socket, ensuring the pins match correctly.
  • Gently press the tuner chip into the socket until it is firmly seated.
  • Double-check the alignment and connection of the chip.

Reinstalling the ECU

With the tuner chip installed, you can now reinstall the ECU back into your Plymouth Road Runner:

  • Reconnect the wiring harness to the ECU, ensuring it clicks into place.
  • Position the ECU back into its original location in the engine bay.
  • Secure the ECU with the bolts you previously removed.

Final Steps

After reinstalling the ECU, follow these final steps to complete the installation:

  • Reconnect the negative battery terminal.
  • Start your Plymouth Road Runner to ensure everything is functioning correctly.
  • Check for any error codes or warning lights on the dashboard.
  • Take your vehicle for a test drive to experience the performance improvements.

Troubleshooting Tips

If you encounter any issues during or after the installation, consider the following troubleshooting tips:

  • Ensure all connections are secure and properly seated.
  • Check for any loose wires or damaged components.
  • Consult the DiabloSport manual for specific error codes or troubleshooting advice.
  • Consider reaching out to a professional mechanic if issues persist.

Conclusion

Installing a Stage 2 tuner chip from DiabloSport on your Plymouth Road Runner can greatly enhance your driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved performance.