Table of Contents
Installing a TurboSmart Dual Port BOV (Blow Off Valve) on your Genesis Coupe can significantly improve boost control and enhance the overall performance of your vehicle. In this step-by-step guide, we will walk you through the installation process to ensure you achieve optimal results.
What You Will Need
- TurboSmart Dual Port BOV
- Basic hand tools (screwdriver, wrench set, etc.)
- Silicone vacuum hose
- Zip ties
- Safety glasses
- Torque wrench
Preparation Steps
Before starting the installation process, it is essential to prepare your workspace and gather all necessary tools and materials.
1. Safety First
Wear safety glasses to protect your eyes from debris. Ensure your vehicle is parked on a flat surface and the engine is cool before starting the installation.
2. Disconnect the Battery
To prevent any electrical issues, disconnect the negative terminal of the battery. This step is crucial for your safety during installation.
Removing the Stock BOV
Now that you are prepared, it’s time to remove the stock BOV from your Genesis Coupe.
1. Locate the Stock BOV
The stock BOV is typically located near the turbocharger. Refer to your vehicle’s manual if you have trouble locating it.
2. Remove the Vacuum Hose
Carefully detach the vacuum hose connected to the stock BOV. You may need to use a screwdriver to loosen any clamps holding the hose in place.
3. Unscrew the BOV
Using a wrench, unscrew the bolts securing the stock BOV to the intake manifold. Keep these bolts as you will need them for the new BOV installation.
Installing the TurboSmart Dual Port BOV
With the stock BOV removed, you can now proceed to install the TurboSmart Dual Port BOV.
1. Prepare the New BOV
Before installation, ensure that the TurboSmart Dual Port BOV is properly prepared. Check that all components are included and in good condition.
2. Install the New BOV
Position the TurboSmart BOV where the stock BOV was located. Align it with the bolt holes and secure it using the bolts you previously removed.
3. Reattach the Vacuum Hose
Connect the silicone vacuum hose to the new BOV. Ensure it is tight and secure to prevent any boost leaks.
4. Check the Installation
Double-check that all connections are secure and that the BOV is properly installed. Make sure there are no loose parts that could lead to malfunction.
Final Steps
Once the TurboSmart Dual Port BOV is installed, it’s time to reconnect the battery and test your installation.
1. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure it is secure and that there are no exposed wires.
2. Start the Engine
Start your Genesis Coupe and allow it to idle for a few minutes. Listen for any unusual noises that may indicate a problem with the installation.
3. Test Drive
Take your vehicle for a test drive to ensure the new BOV is functioning correctly. Pay attention to how the vehicle responds under boost.
Troubleshooting Common Issues
If you experience any issues after installation, consider the following troubleshooting tips:
- Check for vacuum leaks around the BOV and vacuum hose.
- Ensure all bolts are tightened to the manufacturer’s specifications.
- Inspect the BOV for proper operation by revving the engine and listening for the venting sound.
Conclusion
Installing a TurboSmart Dual Port BOV on your Genesis Coupe can greatly enhance your vehicle’s performance and boost control. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved turbo response.