Table of Contents
Installing a Yukon Gear TrueTrac Limited Slip in your Chevy Silverado 1500 can enhance your vehicle’s handling and performance. This guide will walk you through the installation process step-by-step.
Tools and Materials Needed
- Yukon Gear TrueTrac Limited Slip differential
- Socket set
- Wrench set
- Torque wrench
- Jack and jack stands
- Grease
- Safety glasses
- Shop manual for your Silverado
Preparation Steps
Before you begin the installation, ensure that your vehicle is parked on a flat surface and that the engine is off. Follow these preparation steps:
- Gather all tools and materials listed above.
- Put on safety glasses to protect your eyes.
- Lift the vehicle using a jack and secure it with jack stands.
- Remove the rear wheels for better access to the differential.
Removing the Old Differential
To install the Yukon Gear TrueTrac, you must first remove the existing differential:
- Drain the differential fluid by removing the drain plug.
- Remove the cover of the differential by unscrewing the bolts.
- Carefully pull out the old differential assembly.
- Inspect the ring gear and bearings for wear and damage.
Installing the Yukon Gear TrueTrac
With the old differential removed, you can now install the Yukon Gear TrueTrac:
- Clean the differential housing to remove any debris.
- Apply grease to the new Yukon Gear TrueTrac to ensure smooth operation.
- Install the TrueTrac into the differential housing, aligning it with the ring gear.
- Secure the TrueTrac using the provided hardware, following the torque specifications in your shop manual.
Reassembling the Differential
After installing the TrueTrac, reassemble the differential:
- Reinstall the differential cover and secure it with bolts.
- Replace the drain plug and ensure it is tight.
- Fill the differential with the appropriate fluid as specified in your shop manual.
Final Steps
Once everything is reassembled, complete the installation process:
- Reinstall the rear wheels and lower the vehicle back to the ground.
- Start the engine and let it idle for a few minutes.
- Check for leaks around the differential cover and drain plug.
- Test drive the vehicle to ensure proper operation of the TrueTrac.
Conclusion
Installing a Yukon Gear TrueTrac Limited Slip in your Chevy Silverado 1500 can significantly improve traction and handling. By following this step-by-step guide, you can complete the installation successfully and enjoy enhanced performance on and off the road.