Table of Contents
The Toyota Supra MK4 is a legendary sports car known for its performance and tuning potential. Installing AEM roll racing tips can enhance the driving experience and improve efficiency. This guide will walk you through the step-by-step process of installing AEM roll racing tips on your Toyota Supra MK4.
Tools and Materials Needed
- AEM roll racing tips
- Socket wrench set
- Screwdriver set
- Torque wrench
- Safety glasses
- Gloves
- Jack and jack stands
Before starting the installation, ensure you have all the necessary tools and materials at hand. Safety should be your priority, so wear safety glasses and gloves throughout the process.
Step 1: Prepare Your Vehicle
Begin by parking your Toyota Supra MK4 on a flat surface. Engage the parking brake and turn off the engine. Allow the vehicle to cool down if it has been running.
Next, use a jack to lift the front of the car and place jack stands underneath for safety. Ensure the vehicle is secure before proceeding with the installation.
Step 2: Remove the Existing Exhaust Tips
Locate the existing exhaust tips at the rear of your Supra. Using a socket wrench, remove the bolts securing the exhaust tips to the exhaust system. If necessary, use a screwdriver to remove any clamps or brackets holding the tips in place.
Carefully slide the old exhaust tips off the exhaust pipes and set them aside. Ensure that the area is clean and free from debris before installing the new tips.
Step 3: Install the AEM Roll Racing Tips
Take the AEM roll racing tips and align them with the exhaust pipes. Ensure that they fit snugly and are positioned correctly. If your tips come with a gasket, place it between the tip and the exhaust pipe to ensure a tight seal.
Using the socket wrench, secure the new tips by tightening the bolts. Be careful not to overtighten, as this could damage the exhaust system. If clamps are included, ensure they are also securely fastened.
Step 4: Check for Leaks
Once the AEM roll racing tips are installed, it’s important to check for any exhaust leaks. Start the engine and let it idle for a few minutes. Listen for any unusual sounds and check for exhaust fumes escaping from the joints.
If you notice any leaks, turn off the engine and recheck the fittings. Tighten any loose bolts or clamps as necessary to eliminate the leaks.
Step 5: Lower the Vehicle
After confirming that there are no leaks, turn off the engine and allow it to cool. Carefully remove the jack stands and lower the vehicle back to the ground using the jack.
Step 6: Final Inspection
Perform a final inspection of the installation. Ensure that all bolts are tightened properly and that the exhaust tips are securely in place. Check the alignment of the tips to ensure they are straight and symmetrical.
Conclusion
Installing AEM roll racing tips on your Toyota Supra MK4 can enhance both performance and aesthetics. By following this step-by-step guide, you can ensure a successful installation. Enjoy the improved sound and performance of your Supra with the new roll racing tips!