Table of Contents
The Apexi AFC Neo is a popular air-fuel controller that many enthusiasts choose to install in their 2G Eclipse. This guide provides a step-by-step approach to help you through the installation process, ensuring you get the most out of your vehicle’s performance.
Tools and Materials Needed
- Apexi AFC Neo unit
- Wire strippers and crimpers
- Electrical tape
- Screwdrivers (flathead and Phillips)
- Socket set
- Multimeter
- Zip ties
- Installation manual
Step 1: Prepare Your Workspace
Before starting the installation, ensure you have a clean and organized workspace. Gather all your tools and materials to avoid interruptions during the process.
Step 2: Disconnect the Battery
Safety is paramount. Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation.
Step 3: Locate the Wiring Harness
The next step is to locate the wiring harness for your 2G Eclipse. This is typically found near the ECU or under the dashboard. Refer to your vehicle’s manual for specific locations.
Step 4: Connect the AFC Neo Wiring
Using the installation manual, identify the wires that need to be connected to the AFC Neo unit. These typically include:
- Power supply wire
- Ground wire
- Signal wires for the air-fuel ratio
Carefully strip the ends of the wires and connect them according to the instructions. Ensure that all connections are secure and insulated with electrical tape.
Step 5: Mount the AFC Neo Unit
Choose a suitable location to mount the AFC Neo unit. It should be easily accessible for adjustments but secure enough to avoid movement while driving. Use zip ties or screws to secure the unit in place.
Step 6: Reconnect the Battery
Once everything is connected and secured, reconnect the negative terminal of the battery. This will provide power to your AFC Neo unit.
Step 7: Test the Installation
Before taking your Eclipse for a spin, perform a quick test of the AFC Neo. Turn on the ignition without starting the engine and check if the unit powers up correctly. Use a multimeter to verify that all connections are functioning as intended.
Step 8: Adjust Settings
With the unit installed and tested, you can now adjust the settings according to your vehicle’s performance needs. Refer to the user manual for optimal settings based on your modifications.
Step 9: Final Checks
Before hitting the road, double-check all connections, ensuring everything is secure. Make sure there are no loose wires that could interfere with the vehicle’s operation.
Conclusion
Installing an Apexi AFC Neo on your 2G Eclipse can significantly enhance your vehicle’s performance when done correctly. Follow these steps carefully, and you will enjoy the benefits of improved air-fuel management.