Table of Contents
The Chevy Camaro SS is known for its impressive performance, and upgrading to Borla individual throttle bodies can significantly enhance its power and responsiveness. This step-by-step guide will walk you through the installation process to ensure you achieve optimal results.
Tools and Materials Needed
- Socket set
- Torque wrench
- Screwdrivers (flat and Phillips)
- Throttle body gasket
- New intake manifold gasket
- Vacuum hose
- Wire connectors
- Electrical tape
- Shop towels
Preparation Steps
Before starting the installation, it’s essential to prepare your workspace and the vehicle. Follow these steps to ensure everything is ready:
- Park the Camaro on a flat surface and engage the parking brake.
- Disconnect the negative battery terminal to prevent any electrical issues.
- Allow the engine to cool completely before starting work.
Removing the Stock Throttle Body
Begin by removing the stock throttle body to make way for the Borla upgrade. Follow these steps:
- Remove the air intake duct by loosening the clamps and detaching it from the throttle body.
- Disconnect any electrical connectors attached to the throttle body.
- Unbolt the throttle body using the appropriate socket size and carefully lift it off the intake manifold.
- Inspect the old gasket and clean the mounting surface on the intake manifold.
Installing the Borla Individual Throttle Bodies
With the stock throttle body removed, you can now install the Borla individual throttle bodies. Follow these steps:
- Place the new throttle body gasket on the intake manifold, ensuring it is aligned properly.
- Carefully position the Borla throttle bodies onto the gasket and intake manifold.
- Secure the throttle bodies by tightening the bolts to the manufacturer’s specified torque settings.
- Reconnect the electrical connectors to the throttle bodies.
Reconnecting the Air Intake Duct
Once the throttle bodies are securely installed, you’ll need to reconnect the air intake duct:
- Align the air intake duct with the throttle bodies.
- Tighten the clamps to secure the duct in place.
Final Checks and Reconnection
Before you finish up, perform the following final checks:
- Inspect all connections and ensure they are secure.
- Check for any vacuum leaks around the throttle bodies.
- Reconnect the negative battery terminal.
Testing the Installation
With everything reconnected, it’s time to test the installation:
- Start the engine and let it idle for a few minutes.
- Check for any unusual sounds or warning lights on the dashboard.
- Take the Camaro for a test drive to ensure the throttle response is improved.
Conclusion
Installing Borla individual throttle bodies on your Chevy Camaro SS can greatly enhance performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved throttle response and power.