Table of Contents
Upgrading your BMW M2 Competition with an Eventuri Carbon Fiber Intake can enhance performance and give your vehicle a unique look. This guide will walk you through the installation process step-by-step.
Tools and Materials Needed
- Eventuri Carbon Fiber Intake Kit
- Socket Set
- Torque Wrench
- Flathead Screwdriver
- Phillips Screwdriver
- Trim Removal Tool
- Electrical Tape
- Shop Towels
Preparation Steps
Before you start the installation, ensure that you have all the necessary tools and materials ready. Additionally, it’s crucial to work in a well-ventilated area and allow the engine to cool down completely.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical issues during installation.
2. Remove the Engine Cover
Use your socket set to remove the bolts securing the engine cover. Carefully lift the cover off and set it aside.
3. Remove the Factory Intake System
Loosen the clamps on the factory intake tubes using a screwdriver. Disconnect any sensors or hoses attached to the intake system. Once disconnected, remove the factory intake components.
Installing the Eventuri Carbon Fiber Intake
1. Prepare the New Intake
Unpack the Eventuri Carbon Fiber Intake kit and ensure all components are present. Review the installation manual for specific instructions related to your model.
2. Install the Intake Hoses
Attach the new intake hoses to the throttle body and secure them with the provided clamps. Ensure a snug fit to prevent any air leaks.
3. Position the Carbon Fiber Intake
Carefully position the carbon fiber intake in place. Align it with the mounting points and ensure it sits securely without any obstructions.
4. Secure the Intake
Using the provided hardware, secure the intake to the vehicle. Follow the recommended torque specifications to avoid over-tightening.
Finalizing the Installation
1. Reconnect Sensors and Hoses
Reconnect any sensors or hoses that were removed during the disassembly of the factory intake. Double-check all connections for security.
2. Replace the Engine Cover
Once everything is connected, place the engine cover back onto the engine bay. Secure it with the bolts you removed earlier.
3. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure it is tight and secure.
Testing Your Installation
Start your engine and listen for any unusual sounds. Take the vehicle for a short drive to ensure everything is functioning correctly. Monitor the performance and check for any error codes.
Conclusion
Installing the Eventuri Carbon Fiber Intake on your M2 Competition can significantly enhance your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved airflow and engine responsiveness.