Table of Contents
The ProCharger i-2 Supercharger is a popular performance upgrade for Toyota Tundra owners looking to enhance their vehicle’s power and efficiency. This guide will walk you through the step-by-step process of installing the ProCharger i-2 Supercharger on your Tundra, ensuring you achieve optimal performance.
Tools and Materials Needed
- ProCharger i-2 Supercharger Kit
- Socket and wrench set
- Torque wrench
- Flathead and Phillips screwdrivers
- Rubber mallet
- Vacuum line and hose clamps
- Coolant and oil
- Shop towels
- Safety glasses and gloves
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and materials ready. It’s also important to work in a well-ventilated area and wear safety gear to protect yourself during the process.
Step 1: Disconnect the Battery
Begin by disconnecting the negative cable from the battery to prevent any electrical shorts during the installation. Make sure to remove the cable completely from the terminal.
Step 2: Remove the Factory Intake System
Next, remove the factory intake system. This typically involves loosening clamps and removing screws that hold the air filter box and intake tubing in place. Carefully set these components aside for reinstallation later.
Step 3: Remove the Factory Supercharger (if applicable)
If your Tundra is equipped with a factory supercharger, you will need to remove it. Follow the manufacturer’s instructions to safely detach it from the engine, ensuring that all hoses and connections are properly disconnected.
Installing the ProCharger i-2 Supercharger
Step 4: Install the Supercharger Bracket
Using the provided hardware, attach the supercharger bracket to the engine. Make sure to follow the torque specifications outlined in the installation manual for a secure fit.
Step 5: Mount the ProCharger Supercharger
Carefully mount the ProCharger supercharger onto the bracket. Ensure that all alignment holes are properly matched and secure the supercharger in place using the supplied bolts.
Step 6: Connect the Intake and Boost Hoses
Connect the intake and boost hoses to the supercharger. Make sure to use the provided clamps to secure the hoses tightly, preventing any leaks.
Step 7: Install the Fuel Injectors
Replace the factory fuel injectors with the high-performance injectors included in the ProCharger kit. Ensure they are properly seated and secured to prevent fuel leaks.
Finalizing the Installation
Step 8: Reconnect the Battery
Once all components are installed, reconnect the negative battery cable. Ensure that the connection is tight and secure.
Step 9: Check All Connections
Before starting the engine, double-check all connections, hoses, and bolts to ensure everything is properly secured and connected. This step is crucial for preventing leaks and ensuring optimal performance.
Step 10: Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual noises and monitor for leaks. If everything sounds and looks good, you’re ready to take your Tundra for a test drive!
Post-Installation Checks
After the installation, it’s important to perform some checks to ensure everything is functioning correctly. Here are a few steps to follow:
- Check for any leaks around the supercharger and hoses.
- Monitor engine temperatures during your first drive.
- Ensure the supercharger is providing the expected boost.
- Revisit all connections after a few days of driving to ensure they remain secure.
Conclusion
Installing the ProCharger i-2 Supercharger on your Tundra can significantly enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency. Always remember to consult the manufacturer’s manual for specific instructions and safety precautions.