Table of Contents
The RSX Type S is a popular choice among car enthusiasts, especially for those looking to enhance performance. One of the most effective ways to boost power is by installing a supercharger. This article provides a step-by-step guide to installing a Comptech supercharger on your RSX Type S.
Tools and Materials Needed
- Comptech Supercharger Kit
- Socket set
- Torque wrench
- Wrenches
- Screwdrivers
- Vacuum hose
- Throttle body gasket
- Coolant
- Oil for supercharger
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and materials. It’s also important to work in a well-ventilated area and to wear safety glasses and gloves throughout the process.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation.
2. Remove the Engine Cover
Next, remove the engine cover by unscrewing the bolts that hold it in place. Set the cover aside for later reinstallation.
Installing the Supercharger
3. Remove the Intake Manifold
Carefully detach the intake manifold by removing the bolts and disconnecting any attached sensors or hoses. Make sure to label the hoses for easier reinstallation.
4. Install the Supercharger Bracket
Position the supercharger bracket onto the engine and secure it with the provided bolts. Ensure it is aligned correctly according to the instructions in the supercharger kit.
5. Mount the Supercharger
Attach the supercharger to the bracket, making sure to tighten all bolts to the specified torque settings. Refer to the installation manual for the correct torque specifications.
6. Reinstall the Intake Manifold
Reattach the intake manifold, ensuring that all sensors and hoses are properly connected. Replace the throttle body gasket to prevent any air leaks.
Finalizing the Installation
7. Connect the Vacuum Hoses
Connect the vacuum hoses from the supercharger to the appropriate ports on the engine, ensuring a secure fit to maintain proper pressure.
8. Fill the Supercharger with Oil
Fill the supercharger with the recommended oil, as specified in the installation manual. This step is crucial for the longevity and performance of the supercharger.
9. Reconnect the Battery
Once everything is securely in place, reconnect the negative terminal of the battery. Double-check all connections before proceeding.
Testing the Installation
After completing the installation, it’s important to test the vehicle to ensure everything is functioning correctly. Start the engine and listen for any unusual noises.
10. Check for Leaks
Inspect the installation area for any signs of coolant or oil leaks. If any leaks are found, address them immediately before taking the car for a drive.
11. Take a Test Drive
Once you’re confident that there are no leaks, take the RSX Type S for a test drive. Pay attention to how the car performs and make sure the supercharger is functioning as expected.
Conclusion
Installing a Comptech supercharger on the RSX Type S can significantly enhance its performance. By following this step-by-step guide, you can successfully install the supercharger and enjoy the added power and responsiveness of your vehicle.