Table of Contents
Installing an APS cold air intake on your Eclipse GST can significantly improve engine performance and efficiency. This guide will take you through the installation process step-by-step, ensuring that you achieve the best results with your vehicle.
What You’ll Need
- APS Cold Air Intake Kit
- Socket Set
- Wrenches
- Flathead and Phillips Screwdrivers
- Rubber Hose Clamps
- Air Filter Cleaner (optional)
- Safety Glasses
- Gloves
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and parts ready. It’s important to work in a clean and organized environment to avoid losing any components.
1. Safety First
Wear safety glasses and gloves to protect yourself from debris and sharp edges during the installation process.
2. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery. This step is crucial to prevent any electrical shorts while working on the vehicle.
Removing the Stock Intake
To install the APS cold air intake, you first need to remove the stock intake system from your Eclipse GST.
1. Locate the Stock Intake
The stock intake is typically located at the front of the engine bay. Identify the air box, intake piping, and any associated hoses.
2. Remove the Air Box
Using a socket set, remove the bolts securing the air box to the engine bay. Carefully lift the air box out, disconnecting any attached sensors or hoses.
3. Disconnect the Intake Piping
Loosen the hose clamps on the intake piping and remove the piping from the throttle body. Make sure to keep all components for reinstallation.
Installing the APS Cold Air Intake
With the stock intake removed, it’s time to install the APS cold air intake system.
1. Position the New Intake Pipe
Take the new intake pipe from the APS kit and position it to connect to the throttle body. Ensure it aligns properly.
2. Secure the Pipe with Hose Clamps
Once the intake pipe is in position, secure it using the provided rubber hose clamps. Make sure it is tight to prevent any air leaks.
3. Install the Air Filter
Attach the air filter to the end of the intake pipe. Ensure it is secured tightly to allow for optimal airflow.
Final Steps
After installing the APS cold air intake, follow these final steps to complete the installation.
1. Reconnect Any Sensors
If you disconnected any sensors or hoses during the removal of the stock intake, make sure to reconnect them properly.
2. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure it is secured to avoid any electrical issues.
3. Start the Engine
Start your Eclipse GST and let it idle for a few minutes. Listen for any unusual sounds that may indicate a problem with the installation.
Conclusion
Installing the APS cold air intake on your Eclipse GST can enhance performance and efficiency. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved airflow to your engine.