Table of Contents
Installing a cold air intake in your Subaru Forester can significantly improve engine performance and efficiency. This guide will walk you through the step-by-step process of installing the TurboXS cold air intake. Follow these instructions carefully to ensure a successful installation.
Tools and Materials Needed
- TurboXS Cold Air Intake Kit
- Socket set
- Wrench set
- Flathead screwdriver
- Phillips screwdriver
- Torque wrench
- Shop towel or rag
- Safety glasses
Preparation
Before starting the installation, make sure to park your Subaru Forester on a flat surface and turn off the engine. Allow the engine to cool down completely. Gather all the necessary tools and materials listed above.
Step 1: Remove the Engine Cover
Using a socket or wrench, remove the bolts securing the engine cover. Carefully lift the cover off and set it aside in a safe place.
Step 2: Disconnect the Battery
To avoid any electrical issues, disconnect the negative terminal of the battery using a wrench. Make sure it is completely removed from the battery post.
Step 3: Remove the Factory Air Intake System
Locate the factory air intake system. Disconnect the air intake hose from the throttle body by loosening the hose clamp with a screwdriver. Remove any additional bolts or screws securing the factory airbox and lift it out of the engine bay.
Step 4: Install the TurboXS Cold Air Intake
Take the TurboXS cold air intake and position it in the engine bay. Align the intake pipe with the throttle body. Secure it using the provided hose clamp and tighten it with a screwdriver.
Step 5: Connect the Air Filter
Attach the air filter to the end of the intake pipe. Ensure it is seated properly and secure it with the provided clamp.
Step 6: Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure it is tight and secure.
Step 7: Replace the Engine Cover
Carefully place the engine cover back onto the engine bay and secure it with the previously removed bolts.
Final Checks
Before starting your engine, double-check all connections and ensure everything is tightened properly. Make sure there are no tools left in the engine bay. Start the engine and listen for any unusual sounds.
Conclusion
Installing a TurboXS cold air intake in your Subaru Forester is a straightforward process that can enhance your vehicle’s performance. By following these steps, you can ensure a proper installation and enjoy the benefits of improved airflow and efficiency.