Table of Contents
The Grand Cherokee SRT is known for its powerful performance and impressive handling. One way to enhance its capabilities is by installing a cold air intake system, specifically the Roaring Performance Cold Air Intake. This article will guide you through the step-by-step installation process to ensure you get the best out of your vehicle.
Tools and Materials Needed
- Roaring Performance Cold Air Intake Kit
- Socket set
- Ratchet wrench
- Flathead screwdriver
- Phillips screwdriver
- Torque wrench
- Shop towel or rag
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, it is crucial to prepare your workspace and gather all necessary tools and materials. Follow these preparation steps:
- Park the Grand Cherokee SRT on a flat surface.
- Engage the parking brake.
- Allow the engine to cool down completely.
- Disconnect the negative battery terminal to prevent any electrical issues.
Removing the Stock Air Intake System
The first step in the installation process is to remove the stock air intake system. Follow these steps carefully:
- Locate the stock air intake assembly. It is typically found on the driver’s side of the engine bay.
- Remove the screws or bolts securing the air intake duct using a socket set.
- Disconnect the mass air flow (MAF) sensor connector by gently pulling it off.
- Detach the intake duct from the throttle body by loosening the hose clamp with a flathead screwdriver.
- Carefully lift the stock air intake system out of the engine bay and set it aside.
Installing the Roaring Performance Cold Air Intake
With the stock intake removed, it’s time to install the Roaring Performance Cold Air Intake. Follow these steps:
- Begin by placing the new intake tube into position in the engine bay.
- Attach the intake tube to the throttle body, ensuring that it is properly aligned.
- Secure the intake tube with the provided hose clamp, tightening it with a socket set.
- Connect the MAF sensor to the new intake tube, ensuring a snug fit.
- Install the air filter onto the intake tube, securing it with the provided clamp.
- Position the heat shield around the air filter, ensuring it is properly aligned with the intake tube.
Finalizing the Installation
After securing all components, it’s essential to finalize the installation. Follow these steps:
- Double-check all connections and ensure everything is tightened to the manufacturer’s specifications.
- Reconnect the negative battery terminal.
- Start the engine and let it idle for a few minutes to ensure everything is functioning correctly.
- Check for any leaks or unusual noises that may indicate improper installation.
- Take the vehicle for a test drive to experience the enhanced performance.
Maintenance Tips
To keep your Roaring Performance Cold Air Intake functioning optimally, follow these maintenance tips:
- Regularly inspect the air filter for dirt and debris.
- Clean the air filter as needed, following the manufacturer’s instructions.
- Check all connections periodically to ensure they remain secure.
- Monitor the engine performance and listen for any unusual sounds.
Conclusion
Installing a Roaring Performance Cold Air Intake on your Grand Cherokee SRT can significantly enhance its performance and responsiveness. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved airflow and engine efficiency.