Table of Contents
Installing a Hellcat Underdrive Pulley Kit can significantly enhance your vehicle’s horsepower while maintaining reliability. This article provides a comprehensive step-by-step guide to ensure a successful installation.
Tools and Materials Needed
- Socket set
- Torque wrench
- Pulley puller
- Replacement belts
- Grease
- Safety goggles
- Gloves
Before starting the installation, gather all necessary tools and materials to ensure a smooth process.
Preparation Steps
Begin by preparing your vehicle for the installation process. Follow these steps:
- Park the vehicle on a flat surface.
- Disconnect the battery to prevent any electrical issues.
- Remove any components blocking access to the crankshaft pulley.
Removing the Stock Pulley
Once the vehicle is prepared, you can proceed with removing the stock pulley. Follow these steps:
- Use a socket set to remove the bolts securing the stock pulley.
- Attach the pulley puller to the stock pulley.
- Carefully remove the stock pulley using the pulley puller.
Installing the Hellcat Underdrive Pulley
With the stock pulley removed, you’re ready to install the Hellcat Underdrive Pulley. Follow these instructions:
- Apply a thin layer of grease to the crankshaft.
- Align the Hellcat Underdrive Pulley with the crankshaft.
- Push the pulley onto the crankshaft until it is firmly in place.
- Reattach the bolts and tighten them to the manufacturer’s specifications using a torque wrench.
Replacing the Belts
After installing the pulley, you will need to replace the belts to ensure proper functionality. Follow these steps:
- Remove the old belts from the stock pulley.
- Install the new belts around the Hellcat Underdrive Pulley.
- Ensure that the belts are correctly aligned and tensioned.
Final Checks and Reconnection
Before finishing the installation, perform the following checks:
- Double-check all bolts for tightness.
- Inspect the belts for proper alignment and tension.
- Reconnect the battery.
Testing the Installation
After everything is reassembled, it is important to test the installation:
- Start the engine and listen for any unusual noises.
- Check for any signs of belt slippage or misalignment.
- Take the vehicle for a short drive to evaluate performance.
Conclusion
By following these steps, you can successfully install a Hellcat Underdrive Pulley Kit, maximizing your horsepower without compromising reliability. Enjoy the enhanced performance of your vehicle!