Step-by-step Installation of Hyundai Elantra N Performance Cat-back Exhaust for $1,200

by

The Hyundai Elantra N is a performance-oriented vehicle that has garnered attention for its impressive capabilities. One of the most sought-after upgrades for enthusiasts is the cat-back exhaust system. This article will guide you through the step-by-step installation of the Hyundai Elantra N Performance Cat-back Exhaust for approximately $1,200.

Tools and Materials Needed

  • Hyundai Elantra N Performance Cat-back Exhaust
  • Socket set (including 10mm, 12mm, and 14mm sockets)
  • Ratchet and extensions
  • Torque wrench
  • Jack and jack stands
  • Safety glasses
  • Gloves
  • Cutting tool (if needed)
  • Lubricant (WD-40 or similar)

Preparation Steps

Before diving into the installation, ensure that you have all the necessary tools and materials ready. Follow these preparation steps:

  • Park your Hyundai Elantra N on a flat surface.
  • Engage the parking brake for safety.
  • Wear safety glasses and gloves to protect yourself during the installation.

Step 1: Lift the Vehicle

To access the exhaust system, you need to lift the vehicle. Follow these steps:

  • Use a jack to lift the rear of the vehicle.
  • Secure the vehicle on jack stands to ensure stability.

Step 2: Remove the Stock Exhaust

Now, it’s time to remove the stock exhaust system. Here’s how:

  • Locate the bolts that secure the stock exhaust to the catalytic converter.
  • Using the appropriate socket, remove the bolts carefully.
  • Disconnect any hangers or rubber mounts holding the exhaust in place.
  • If necessary, use a cutting tool to remove the exhaust if it is too corroded.

Step 3: Install the New Cat-back Exhaust

With the stock exhaust removed, you can now install the new cat-back exhaust. Follow these steps:

  • Position the new cat-back exhaust under the vehicle.
  • Connect the exhaust to the catalytic converter using the provided bolts.
  • Ensure the exhaust is aligned properly and not touching any other components.
  • Secure the hangers or rubber mounts to hold the exhaust in place.

Step 4: Tighten All Connections

After the exhaust is in place, it’s crucial to tighten all connections to ensure a secure fit:

  • Use a torque wrench to tighten the bolts to the manufacturer’s specifications.
  • Double-check all hangers and mounts to ensure they are secure.

Step 5: Lower the Vehicle

Once everything is tightened, you can lower the vehicle:

  • Remove the jack stands carefully.
  • Lower the vehicle back to the ground using the jack.

Step 6: Test the New Exhaust System

With the exhaust installed, it’s important to test the system:

  • Start the engine and listen for any unusual noises.
  • Check for leaks around the connections.
  • Take the car for a short drive to ensure everything is functioning properly.

Conclusion

Installing a Hyundai Elantra N Performance Cat-back Exhaust can enhance your vehicle’s performance and sound. By following these steps, you can successfully complete the installation for around $1,200. Enjoy the improved driving experience and the satisfaction of completing the installation yourself!