Table of Contents
Installing KMC beadlock wheels on a high-performance 700 HP drag car requires precision and care. This guide will walk you through the step-by-step process to ensure a successful installation.
Tools and Materials Needed
- KMC beadlock wheels
- Wheel spacers (if necessary)
- Torque wrench
- Impact gun
- Jack and jack stands
- Socket set
- Beadlock hardware kit
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, ensure you have all necessary tools and materials. Safety is paramount, so wear gloves and safety glasses throughout the process.
1. Lift the Vehicle
Using a jack, lift the vehicle off the ground and secure it with jack stands. Ensure the car is stable before proceeding.
2. Remove Existing Wheels
Loosen the lug nuts on the existing wheels using a socket set. Once loosened, remove the lug nuts completely and take off the wheels.
Installing KMC Beadlock Wheels
With the vehicle lifted and existing wheels removed, you can now proceed to install the KMC beadlock wheels.
3. Position the Beadlock Wheel
Carefully position the KMC beadlock wheel onto the wheel hub. Ensure that the holes align with the wheel studs.
4. Attach the Beadlock Ring
Place the beadlock ring onto the wheel, ensuring it sits flush. Align the holes of the ring with the wheel’s holes.
5. Insert Beadlock Hardware
Using the beadlock hardware kit, insert the bolts through the beadlock ring into the wheel. Hand-tighten the bolts to secure the ring in place.
6. Torque the Beadlock Bolts
Utilize a torque wrench to tighten the beadlock bolts to the manufacturer’s specified torque settings. This ensures a secure fit.
Finalizing the Installation
After the beadlock wheels are securely attached, it’s time to finalize the installation.
7. Install the Lug Nuts
Align the wheel with the wheel studs and insert the lug nuts. Hand-tighten them to hold the wheel in place.
8. Torque the Lug Nuts
Using a torque wrench, torque the lug nuts to the recommended specifications. This step is critical for wheel safety during high-speed runs.
9. Lower the Vehicle
Carefully lower the vehicle back to the ground using the jack. Remove the jack stands and ensure the car is stable.
Post-Installation Checks
After installation, it’s important to perform a few checks before taking the car for a test drive.
10. Inspect the Installation
Check that all bolts and lug nuts are securely tightened. Look for any signs of misalignment or issues with the beadlock ring.
11. Test Drive
Take the car for a short test drive to ensure everything is functioning properly. Pay attention to any unusual noises or vibrations.
12. Re-check Torque
After the test drive, re-check the torque on the lug nuts and beadlock bolts. This is crucial for safety and performance.
Conclusion
Installing KMC beadlock wheels on a 700 HP drag car is a straightforward process when following these steps. Proper installation ensures performance and safety on the track.