Table of Contents
The Mercedes AMG Performance Brake Upgrade Kit is designed to enhance the stopping power of your vehicle, providing better performance on the road or track. This article outlines a step-by-step installation process that can help you upgrade your braking system effectively.
Tools and Materials Needed
- Mercedes AMG Performance Brake Upgrade Kit
- Jack and jack stands
- Socket set
- Torque wrench
- Brake cleaner
- New brake fluid
- Rags
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, it is crucial to prepare your workspace and vehicle. Follow these steps to ensure a safe and efficient process:
- Park your vehicle on a flat surface and engage the parking brake.
- Gather all tools and materials needed for the installation.
- Wear safety glasses and gloves to protect yourself during the process.
- Disconnect the battery to prevent any electrical issues.
Step 1: Remove the Wheel
To access the brake components, you must first remove the wheel. Here’s how:
- Loosen the lug nuts slightly while the vehicle is still on the ground.
- Using the jack, lift the vehicle and secure it with jack stands.
- Remove the lug nuts completely and take off the wheel.
Step 2: Remove the Old Brake Components
With the wheel removed, you can now access the brake caliper and rotor:
- Locate the caliper bolts and use the socket set to remove them.
- Carefully slide the caliper off the rotor and hang it using a bungee cord or similar tool to avoid damaging the brake line.
- Remove the rotor by unscrewing the retaining screws, if applicable, and pulling it off the wheel hub.
Step 3: Install the New Brake Rotor
Now that the old rotor is removed, it’s time to install the new performance rotor:
- Clean the hub surface with brake cleaner to ensure proper contact.
- Position the new rotor onto the hub and secure it with retaining screws if necessary.
Step 4: Install the New Brake Caliper and Pads
Next, install the new caliper and brake pads:
- Remove the new brake pads from their packaging and insert them into the caliper.
- Carefully position the new caliper over the rotor and align it with the mounting bracket.
- Tighten the caliper bolts to the manufacturer’s specified torque settings.
Step 5: Reinstall the Wheel
With the new brake components installed, it’s time to put the wheel back on:
- Slide the wheel back onto the hub and hand-tighten the lug nuts.
- Lower the vehicle from the jack stands and tighten the lug nuts in a crisscross pattern to the manufacturer’s specifications.
Step 6: Repeat for Other Wheels
To complete the brake upgrade, repeat the installation process for the other wheels:
- Follow the same steps to remove the wheel, old brake components, and install the new ones.
- Ensure all components are installed securely before moving on.
Step 7: Bleed the Brakes
After installing the new brake components, it’s essential to bleed the brakes to remove any air from the system:
- Locate the brake bleeder valve on each caliper.
- Using a helper, have them pump the brake pedal while you open and close the bleeder valve to release air.
- Repeat until you see a steady stream of brake fluid without bubbles.
Step 8: Refill Brake Fluid
Once the brakes are bled, check the brake fluid level in the reservoir:
- Add new brake fluid as needed to reach the recommended level.
- Ensure the cap is securely closed after refilling.
Step 9: Test Drive
After completing the installation and ensuring everything is secure, it’s time for a test drive:
- Start the vehicle and gently press the brake pedal to ensure the brakes engage properly.
- Take the vehicle for a short drive in a safe area, testing the brakes at low speeds.
- Check for any unusual noises or vibrations during braking.
Conclusion
Upgrading to the Mercedes AMG Performance Brake Upgrade Kit can significantly enhance your vehicle’s stopping power. By following these steps, you can ensure a successful installation, leading to improved performance and safety on the road.