Table of Contents
The Auburn Pro Limited Slip differential is a popular upgrade for the 2020 Dodge Charger, enhancing traction and performance. This guide will walk you through the step-by-step installation process to ensure you can complete the installation with confidence.
Tools and Materials Needed
- Auburn Pro Limited Slip Differential Kit
- Socket set
- Torque wrench
- Jack and jack stands
- Drain pan
- Gear oil
- Shop towels
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure your vehicle is parked on a flat surface. Engage the parking brake and wear safety glasses and gloves for protection.
Step 1: Lift the Vehicle
Using a jack, lift the rear of the Dodge Charger and secure it with jack stands. Make sure the vehicle is stable before proceeding.
Step 2: Remove the Rear Differential Cover
Place a drain pan under the rear differential to catch any fluid. Remove the bolts securing the differential cover using a socket wrench. Carefully pry the cover off and allow the old fluid to drain completely.
Step 3: Remove the Old Differential
Once the fluid is drained, remove the bolts securing the differential assembly. Carefully pull the differential out of the housing. Be cautious of any remaining fluid.
Step 4: Install the Auburn Pro Limited Slip Differential
Position the Auburn Pro Limited Slip differential into the housing. Ensure it fits snugly and aligns properly with the axle shafts. Replace the bolts and tighten them to the manufacturer’s specifications using a torque wrench.
Step 5: Reinstall the Differential Cover
Clean the differential cover and the mating surface. Apply a bead of gasket maker or replace the gasket if necessary. Reattach the cover and secure it with bolts, tightening them evenly.
Refilling the Differential
After the cover is securely in place, it’s time to refill the differential with new gear oil. Locate the fill plug on the differential housing.
Step 6: Add Gear Oil
Using a pump or a funnel, fill the differential with the recommended type of gear oil until it reaches the fill hole. Ensure not to overfill.
Step 7: Reinstall the Fill Plug
Replace the fill plug and tighten it securely. Make sure there are no leaks around the differential cover or fill plug.
Final Steps
With the installation complete, it’s time to lower the vehicle back to the ground. Remove the jack stands and carefully lower the vehicle using the jack.
Step 8: Test Drive
Once the vehicle is on the ground, take it for a test drive to ensure everything is functioning properly. Listen for any unusual noises and check for leaks.
Conclusion
Installing the Auburn Pro Limited Slip differential in a 2020 Dodge Charger can significantly improve your vehicle’s performance. By following these steps, you can ensure a successful installation. Always refer to the manufacturer’s instructions for specific details related to your vehicle model.