Table of Contents
The HPE Supercharged Ram TRX Kit is designed for performance enthusiasts looking to boost their truck’s horsepower significantly. With this kit, you can elevate your Ram TRX from its stock power to an impressive 800+ horsepower. This article provides a detailed step-by-step guide to help you through the installation process.
Tools and Materials Needed
- HPE Supercharged Ram TRX Kit
- Basic hand tools (sockets, wrenches, screwdrivers)
- Torque wrench
- Jack and jack stands
- Safety goggles and gloves
- Coolant and oil (for refills)
Preparation Steps
Before you begin the installation, ensure that you have a clean and organized workspace. Gather all the necessary tools and materials. It is also advisable to read through the installation manual provided with the HPE kit to familiarize yourself with the components and steps involved.
1. Safety First
Always wear safety goggles and gloves when working on your vehicle. Make sure the truck is parked on a flat surface, and engage the parking brake. Disconnect the battery to prevent any electrical issues during the installation.
2. Lift the Vehicle
Using a jack, lift the front of the truck and secure it with jack stands. This will give you better access to the engine bay and other components that need to be removed.
Removing Stock Components
To install the HPE Supercharged kit, you will need to remove several stock components. Follow these steps carefully to avoid damaging any parts.
1. Remove the Engine Cover
Begin by removing the engine cover. This usually involves unscrewing a few bolts. Set the cover aside in a safe place.
2. Disconnect the Air Intake
Next, disconnect the air intake system. This includes removing the air filter and the intake tube. Be cautious not to damage any sensors attached to the intake.
3. Remove the Stock Supercharger (if applicable)
If your Ram TRX is equipped with a stock supercharger, it will need to be removed. Follow the specific instructions in the manual for detaching it safely.
Installing the HPE Supercharged Kit
With the stock components removed, you can now begin the installation of the HPE Supercharged Ram TRX Kit.
1. Install the New Supercharger
Carefully position the new supercharger in place. Make sure it aligns correctly with the engine mounting points. Use the provided bolts to secure it, ensuring they are tightened to the specified torque settings.
2. Reconnect the Air Intake
Reconnect the air intake system to the new supercharger. Ensure that all clamps and connections are tight to prevent any air leaks.
3. Install Additional Components
Install any additional components that come with the HPE kit, such as upgraded fuel injectors, intercooler, and any necessary hoses. Refer to the installation manual for specific instructions on these parts.
Finalizing the Installation
Once all components are installed, it’s time to finalize the installation and prepare for testing.
1. Reinstall the Engine Cover
Place the engine cover back onto the engine and secure it with the bolts you previously removed.
2. Reconnect the Battery
Reconnect the battery and ensure all electrical connections are secure.
3. Check Fluid Levels
Check the coolant and oil levels. Top off if necessary before starting the engine.
Testing the Installation
With everything installed, it’s time to test the performance of your newly supercharged Ram TRX.
1. Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual sounds that may indicate a problem.
2. Take a Test Drive
After the engine has warmed up, take your truck for a test drive. Pay attention to the throttle response and overall performance. Make sure everything feels smooth and powerful.
Conclusion
Installing the HPE Supercharged Ram TRX Kit can transform your truck into a high-performance machine. By following these step-by-step instructions, you can achieve over 800 horsepower and enjoy an exhilarating driving experience. Always remember to adhere to safety guidelines and consult professionals if you encounter any difficulties during the installation process.