Table of Contents
The Accel Supercoil Ignition System is a popular upgrade for those looking to enhance the performance of their engines. By improving spark energy and combustion efficiency, this system can provide a significant horsepower boost, estimated at around 25 HP. In this guide, we will walk you through the step-by-step installation process of the Accel Supercoil Ignition System.
Tools and Materials Needed
- Accel Supercoil Ignition System kit
- Socket set
- Wrench set
- Screwdriver set
- Wire cutters/strippers
- Electrical tape
- Multimeter
- Safety goggles
- Gloves
Preparation
Before starting the installation, ensure that the engine is turned off and cool. Disconnect the battery to prevent any electrical accidents. Wear safety goggles and gloves to protect yourself during the installation process.
Step 1: Remove the Old Ignition System
Begin by locating the existing ignition system components. This typically includes the ignition coil, spark plug wires, and any associated wiring harnesses. Carefully disconnect the wiring from the old ignition coil and remove it from its mounting location.
Next, remove the spark plug wires from the ignition coil and spark plugs. It is advisable to label these wires to ensure correct installation of the new system later on.
Step 2: Install the Accel Supercoil
Take the Accel Supercoil from the kit and mount it in the location of the old ignition coil. Use the provided hardware to secure it firmly in place. Ensure that the mounting is stable to avoid any vibrations that could lead to disconnection.
Step 3: Connect the Wiring Harness
Using the wiring diagram included with the Accel Supercoil kit, connect the wiring harness to the new ignition coil. Make sure to match the colors and labels correctly. Use wire cutters and strippers if necessary to prepare the wires for connection.
Step 4: Attach Spark Plug Wires
Connect the new spark plug wires to the Accel Supercoil. Ensure that each wire is connected to the correct cylinder as per the engine’s firing order. This is crucial for optimal performance and engine efficiency.
Step 5: Reconnect the Battery
Once all connections are secure, reconnect the battery. This will power up the new ignition system. Before starting the engine, double-check all connections to ensure they are tight and correctly installed.
Step 6: Test the Ignition System
Start the engine and listen for any irregular sounds that may indicate a problem. Use a multimeter to check the voltage at the ignition coil and ensure it is within the specified range. If everything checks out, the installation is successful.
Step 7: Fine-tuning and Adjustments
After successful installation, you may want to fine-tune the ignition timing to maximize performance. Consult your engine’s manual for the recommended timing settings. Make adjustments as necessary and retest the engine performance.
Conclusion
The Accel Supercoil Ignition System can significantly enhance your engine’s performance, providing a boost of up to 25 HP. By following these step-by-step instructions, you can successfully install the system yourself. Always remember to prioritize safety and double-check your work to ensure optimal results.