Table of Contents
The installation of a Mopar electronic ignition system on a 1965 Plymouth Valiant can significantly enhance the vehicle’s performance and reliability. This guide provides a comprehensive step-by-step approach to successfully complete the installation.
Tools and Materials Needed
- Mopar electronic ignition kit
- Basic hand tools (screwdrivers, wrenches)
- Wire cutters and strippers
- Multimeter
- Heat shrink tubing
- Electrical tape
- Service manual for the 1965 Plymouth Valiant
Preparation Steps
Before starting the installation, ensure that you have all the necessary tools and materials at hand. It is also advisable to wear safety glasses and gloves for protection during the process.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
2. Remove the Old Ignition System
Carefully remove the existing ignition components, including the points, condenser, and any associated wiring. Refer to the service manual for specific instructions related to your vehicle.
Installing the Electronic Ignition System
3. Install the Ignition Module
Locate the ignition module included in your Mopar electronic ignition kit. Mount the module in a suitable position, ensuring it is securely fastened and away from excessive heat sources.
4. Connect the Wiring
Follow the wiring diagram provided in the Mopar kit. Connect the wires from the ignition module to the appropriate terminals on the coil and the battery. Use heat shrink tubing and electrical tape to secure connections and prevent short circuits.
5. Install the New Coil
Replace the old ignition coil with the new one included in your kit. Ensure that the connections are tight and secure.
Finalizing the Installation
6. Reconnect the Battery
Once all components are installed and connections are secure, reconnect the negative terminal of the battery.
7. Check the System
Use a multimeter to check the voltage at the ignition coil. Ensure that it falls within the specifications provided in the Mopar kit. This step is crucial for confirming that the installation was successful.
8. Test Drive
Finally, take your 1965 Plymouth Valiant for a test drive. Pay attention to the engine’s performance and responsiveness. If everything runs smoothly, the installation is complete!
Troubleshooting Common Issues
If you encounter any issues during or after installation, consider the following troubleshooting tips:
- Check all electrical connections for tightness and corrosion.
- Ensure the ignition module is properly grounded.
- Verify that the coil is receiving power.
- Consult the service manual for diagnostic procedures.
Conclusion
Installing a Mopar electronic ignition system on a 1965 Plymouth Valiant is a rewarding project that can greatly improve the vehicle’s performance. By following this step-by-step guide, you can successfully upgrade your ignition system and enjoy enhanced reliability on the road.