Step-by-step: Installing an Airaid Mxp Cold Air Intake on Ram 2500 for a $400 Power Boost

by

Installing an Airaid MXP Cold Air Intake on your Ram 2500 can significantly enhance your vehicle’s performance, providing a power boost for a reasonable investment. In this guide, we will walk you through the step-by-step process of installation, ensuring you achieve the best results while maximizing your engine’s potential.

Tools and Materials Needed

  • Airaid MXP Cold Air Intake Kit
  • Socket wrench set
  • Flathead screwdriver
  • Phillips screwdriver
  • Torque wrench
  • Shop towels
  • Safety glasses

Preparation Before Installation

Before you begin the installation, it’s essential to prepare your workspace and vehicle. Follow these steps:

  • Park your Ram 2500 on a level surface.
  • Turn off the engine and allow it to cool completely.
  • Disconnect the negative battery terminal to avoid any electrical issues.
  • Gather all tools and materials needed for the installation.

Step 1: Remove the Factory Air Intake System

Begin by removing the factory air intake system. Follow these sub-steps:

  • Loosen the clamps on the factory intake tube using a socket wrench.
  • Remove the intake tube by gently pulling it away from the throttle body.
  • Detach the air filter box by unscrewing any bolts or screws holding it in place.
  • Carefully lift the air filter box out of the engine bay.

Step 2: Install the Airaid MXP Cold Air Intake

Now that the factory system is removed, you can install the Airaid MXP Cold Air Intake. Follow these steps:

  • Place the Airaid air filter box into the engine bay, ensuring it fits securely.
  • Connect the intake tube to the throttle body, making sure it aligns properly.
  • Tighten the clamps on the intake tube using the socket wrench.
  • Attach the Airaid air filter to the intake tube, securing it with the provided clamp.

Step 3: Reconnect Electrical Connections and Battery

After the intake is installed, it’s time to reconnect any electrical connections and the battery. Follow these steps:

  • Reconnect any sensors or electrical connections that were detached during the removal process.
  • Reattach the negative battery terminal and tighten it securely.
  • Double-check all connections and fittings to ensure everything is in place.

Step 4: Final Checks and Testing

Before you hit the road, it’s essential to perform some final checks:

  • Start the engine and listen for any unusual noises.
  • Check for any air leaks around the intake system.
  • Ensure that the engine runs smoothly and without any warning lights on the dashboard.

Conclusion

Installing an Airaid MXP Cold Air Intake on your Ram 2500 is a straightforward process that can lead to significant performance improvements. With just a few tools and careful attention to detail, you can achieve a power boost for around $400. Enjoy your enhanced driving experience!