Table of Contents
The Veloster N is a popular choice among car enthusiasts, known for its sporty performance and dynamic handling. For those looking to enhance their driving experience, upgrading the turbocharger can significantly boost horsepower and torque. This guide will walk you through the process of installing a Garrett GTX2860R turbocharger to achieve approximately 320 horsepower.
Tools and Materials Needed
- Garrett GTX2860R turbocharger
- Turbocharger installation kit
- Basic hand tools (wrenches, sockets, etc.)
- Torque wrench
- Boost gauge
- Intercooler piping
- Engine oil
- Coolant
- Shop towels
- Safety glasses and gloves
Preparation Steps
Before starting the installation, make sure you have all the necessary tools and materials ready. It’s also important to work in a well-ventilated area and wear safety gear.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts or accidents during the installation process.
2. Remove the Engine Cover
Next, remove the engine cover by loosening the bolts or clips that hold it in place. This will give you access to the turbocharger and surrounding components.
Removing the Stock Turbocharger
With the engine cover removed, you can now proceed to remove the stock turbocharger. Follow these steps carefully to ensure a smooth removal process.
1. Disconnect the Exhaust and Intake Piping
Begin by disconnecting the exhaust and intake piping connected to the stock turbocharger. Use the appropriate tools to loosen the clamps and remove the piping carefully.
2. Remove the Wastegate Actuator
Next, disconnect the wastegate actuator from the stock turbocharger. Make sure to note the orientation of the actuator for the new installation.
3. Unbolt the Turbocharger
Using a torque wrench, unbolt the stock turbocharger from the manifold. Be cautious as some bolts may be in tight spaces.
4. Remove the Stock Turbocharger
Carefully remove the stock turbocharger from the engine bay. Ensure that no debris falls into the engine during this process.
Installing the Garrett GTX2860R Turbocharger
Now that the stock turbocharger is removed, you can proceed with the installation of the Garrett GTX2860R turbocharger.
1. Position the New Turbocharger
Position the Garrett GTX2860R turbocharger onto the manifold. Make sure it aligns properly with the mounting points.
2. Bolt the Turbocharger in Place
Using the torque wrench, bolt the new turbocharger securely to the manifold. Follow the manufacturer’s specifications for torque settings.
3. Reconnect the Wastegate Actuator
Reconnect the wastegate actuator to the new turbocharger, ensuring it is properly aligned and secured.
4. Reconnect Exhaust and Intake Piping
Reconnect the intake and exhaust piping to the Garrett GTX2860R turbocharger. Make sure all clamps are tightened securely to prevent any leaks.
Final Steps
After installing the turbocharger, there are a few final steps to ensure everything is set up correctly.
1. Check All Connections
Double-check all connections, including hoses, clamps, and electrical connections. Make sure everything is secure and properly connected.
2. Refill Engine Oil and Coolant
Refill the engine oil and coolant as needed. It’s essential to ensure that the engine has adequate lubrication and cooling.
3. Reconnect the Battery
Reconnect the negative terminal of the battery. This will allow the engine to start and run properly.
4. Start the Engine
Start the engine and let it idle for a few minutes. Check for any leaks or unusual noises. Monitor the boost gauge to ensure the turbocharger is functioning correctly.
Conclusion
Installing a Garrett GTX2860R turbocharger on your Veloster N can significantly enhance performance, achieving up to 320 horsepower. By following this installation guide, you can ensure a successful upgrade, improving your driving experience and enjoyment of the vehicle.