Table of Contents
The installation of a front mount intercooler (FMIC) can significantly enhance the performance of your Subaru WRX. In this article, we will guide you through the step-by-step process of installing the TurboXS 24x12x3 kit. With the right tools and some mechanical knowledge, you can improve your vehicle’s efficiency and power output.
Tools and Materials Needed
- TurboXS 24x12x3 Front Mount Intercooler Kit
- Socket set
- Wrenches
- Screwdrivers
- Hose clamps
- Heat-resistant silicone couplers
- Torque wrench
- Zip ties
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, ensure that you have all the necessary tools and materials ready. It is also important to work in a well-ventilated area and wear safety glasses and gloves for protection.
Step 1: Remove the Front Bumper
Begin by removing the front bumper to gain access to the stock intercooler. Use your socket set to unscrew the bolts securing the bumper. Be cautious while detaching the bumper to avoid damaging any clips.
Step 2: Disconnect the Stock Intercooler
Once the bumper is off, locate the stock intercooler. Disconnect the piping and any electrical connectors attached to it. Remove the bolts holding the stock intercooler in place and take it out carefully.
Installing the TurboXS FMIC
Step 3: Position the New Intercooler
Take the TurboXS FMIC and position it where the stock intercooler was located. Ensure it is centered and aligned correctly. This will help in connecting the piping without any issues later on.
Step 4: Install the Piping
Begin connecting the piping that comes with the TurboXS kit. Use heat-resistant silicone couplers for better sealing and flexibility. Secure the couplers with hose clamps to prevent any leaks.
Step 5: Secure the Intercooler
Once the piping is in place, use the provided brackets to secure the intercooler. Make sure everything is tightened to avoid any movement during driving. Use a torque wrench to ensure proper tightness.
Final Steps
Step 6: Reinstall the Front Bumper
With the intercooler installed, it’s time to put the front bumper back on. Align it carefully and secure it with the bolts you removed earlier. Make sure all clips are properly attached to avoid any rattling.
Step 7: Check for Leaks
Before taking your WRX for a test drive, check all connections for leaks. Start the engine and let it idle while inspecting the intercooler and piping. If you notice any leaks, tighten the connections or replace any faulty parts.
Conclusion
Installing the TurboXS 24x12x3 front mount intercooler can greatly enhance your Subaru WRX’s performance. By following these steps, you can ensure a successful installation that will lead to improved power and efficiency. Always remember to perform regular checks and maintenance on your intercooler system to keep your vehicle running at its best.