Wrx Headers Installation Tips: Maximizing Sound and Performance with Turboxs

by

The Subaru WRX is known for its performance and unique sound. Upgrading to TurboXS headers can significantly enhance both aspects. In this article, we will explore tips for installing WRX headers to maximize sound and performance.

Understanding WRX Headers

Headers are a crucial part of your vehicle’s exhaust system. They replace the factory exhaust manifold and allow exhaust gases to exit the engine more efficiently. This can lead to increased horsepower, improved throttle response, and a more aggressive exhaust note.

Benefits of TurboXS Headers

TurboXS headers are designed to improve performance and sound. Some key benefits include:

  • Increased Horsepower: Enhanced exhaust flow can lead to significant power gains.
  • Improved Sound: TurboXS headers provide a deeper, more aggressive exhaust note.
  • Durability: Made from high-quality materials, TurboXS headers are built to last.
  • Better Throttle Response: Reduced back pressure improves engine responsiveness.

Preparation for Installation

Before you start the installation process, proper preparation is essential. Here are some steps to follow:

  • Gather Tools: Ensure you have all necessary tools, including wrenches, sockets, and a torque wrench.
  • Read Instructions: Familiarize yourself with the TurboXS installation manual.
  • Safety Gear: Wear gloves and safety glasses to protect yourself during the installation.
  • Vehicle Preparation: Ensure your vehicle is parked on a flat surface and the engine is cool.

Step-by-Step Installation Guide

1. Remove the Old Headers

Begin by removing the factory headers. Follow these steps:

  • Disconnect the battery to prevent any electrical issues.
  • Remove any components obstructing header access, such as the air intake or heat shields.
  • Unbolt the factory headers from the engine and exhaust system.
  • Carefully remove the headers from the engine bay.

2. Prepare the New Headers

Before installing the TurboXS headers, ensure they are ready:

  • Inspect the headers for any damage.
  • Clean the mating surfaces to ensure a proper seal.
  • Apply anti-seize compound to the bolts to prevent them from sticking.

3. Install the TurboXS Headers

Now it’s time to install the new headers:

  • Position the TurboXS headers in place, aligning them with the engine ports.
  • Hand-tighten the bolts to secure the headers without fully tightening.
  • Once all bolts are in place, use a torque wrench to tighten them to the manufacturer’s specifications.

4. Reassemble the Components

After the headers are installed, reassemble any components you removed:

  • Reconnect the exhaust system to the new headers.
  • Reinstall any heat shields or air intake components.
  • Reconnect the battery.

5. Test the Installation

Once everything is back in place, it’s crucial to test your installation:

  • Start the engine and listen for any unusual noises.
  • Check for exhaust leaks around the header connections.
  • Take the vehicle for a short test drive to ensure proper performance.

Tuning Your WRX

After installing TurboXS headers, consider tuning your WRX to maximize performance gains. Tuning can optimize air-fuel ratios and adjust ignition timing, further enhancing your vehicle’s capabilities.

Conclusion

Installing TurboXS headers can significantly improve the sound and performance of your Subaru WRX. By following these tips and steps, you can ensure a successful installation that maximizes your vehicle’s potential. Enjoy the enhanced driving experience that comes with your new headers!